Flm lamp house installation manual r5976922/03 18/11/2008.
Barco nv events noordlaan 5, b-8520 kuurne phone: +32 56.36.89.70 fax: +32 56.36.88.24 e-mail: sales.Events@barco.Com visit us at the web: www.Barco.Com printed in belgium.
1. Installation process 1. Installation process about this chapter this chapter describes how to replace the (universal) lamp house from the flm projector. Adapted software for universal lamp house the flm projector software must be upgraded to version 1.7.17 or later prior to using the universal la...
1. Installation process image 1-1 2. Remove the lamp cover from the projector doing the following: a) gently pull out the left bottom corner (a) of the lamp cover, b) then gently pull out the left top corner (b) of the lamp cover, c) then move the lamp cover away from the projector (c). Image 1-2 1....
1. Installation process image 1-3 4. Clasp the lamp house by the handles and pull the lamp house out of the projector. Image 1-4 while starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not possible to start up the projector. 1.4 installation of ...
1. Installation process 3. Clasp the lamp house by its handles and gently slide the lamp house into its socket. Note that the compartment is provided with guides (g) to position the lamp house correctly. G c image 1-5 4. Push the lamp house forward until it slides fully into the projector. 5. Secure...
1. Installation process image 1-7 2. Secure the lamp cover by locking the two captive screws at the right side of the lamp cover. Image 1-8 r5976922 flm lamp house 18/11/2008 5.
