Barco MFGD 3220 D User Manual - 2.4 Connecting The Signals
of
19
MFGD 3220D User's Guide
12
2.4 Connecting the signals
To get access to the connectors, open the cover
of the connector compartment by pulling down the
2 clips of the cover.
To connect the video & sync signals:
1
Connect one end of the video cable to the
DVI input (5) of the display.
2
Connect the other end of the video cable to
the video output of your video source
(Computer graphics board with digital video
output).
3
Route the cable so that it enters the
connector compartment at the place where
the cover is bulged.
Vid1
Vid2
Example of signal connection in a Coronis dual-
head system
To connect the power:
1
Connect the output of the 12V DC power
supply to the DC input (6) of the display.
2
Connect one end of the proper power
cable to the AC input of the 12V DC power
supply.