Barco NGS-D200 User Manual - page 65
Chapter 14: Administration
Chapter 14: Administration
The following topics are covered in this chapter:
14.1 Administration
57
14.2 Management Settings
58
The Administration Menu allows you to configure the device to be used in either Managed or Standalone Mode
(connections with or without the use of a 4.x Management Server respectively), point the device to a Management Server
(when used in Managed Mode), and also change the default login credentials used to access the Web UI.
14.1 Administration
14.1.1 Management Status
N
OTE: This menu is only applicable to users of the 4.x Collaboration Suite.
The Management Status section allows you to check to see if your device is logged in to the Management Server. This is
helpful if you are having trouble managing the system as part of a 4.x environment.
14.1.2 System Control
System control allows you reboot, shutdown, revert to defaults, and switch the gender of the NGS-D200.
l
Factory Reset: Resets the NGS-D200 to factory defaults
l
Reboot : Reboots the system
l
Shutdown : Initiates a system shutdown cycle
l
Encoder/Decoder: Switches the NGS-D200 from an encoder to decoder, or vice versa
N
OTE: After changing the gender of the system, the system will reboot. After the system comes back online, make
sure to click "Save Settings" to ensure the device retains this selection.
14.1.3 Upgrade
You can upgrade the software/firmware version of the system.
NGS-D200 can be upgraded from
l
Web UI of the box,
l
BCS Management System (Refer to BCS Admin UI Guide)
l
TFN CMS system (Refer to TransForm N installation manual).
14.1.3.1 Procedure to upgrade via Web UI
Prerequisites - a webserver needs to be installed (if not already, a webserver like WampServer can be installed
http://www.wampserver.com/en/ )
1. Untar the NGS-D200 Firmware upgrade package into a directory. It will create a directory called IMAGES
2. Place the IMAGES folder in root folder of webserver (normally a directory on webserver like www)
57
NGS-D200 User Guide