Barco PJWU-101B User Manual - page 74

PJWU-101B  17/10/2014

66

14.Lamp and Filter Maintenance

8.  Reconnect power to the projector and reset the lamp usage timer. Refer to 

 page 53: 10.8  Lamp1 Run Time

 and 

 page 

53: 10.9  Lamp2 Run Time

 While starting up the projector, the electronics  detect if a lamp is installed.  If no lamp is installed, it is not 

possible to start up the projector.

14.2  Replace the filter (for inlet 

Ventilation)

Make sure to replace the filter when it is required to keep the air intake clear of dust, and prevent possible over temperature 

issue of the projector due to the clog of filter.

C

AUTION: 

The high density filter must be replaced on a regular basis, depending on the environment 

condi- tions of the projector.  Suggest to replace filter every 500 hours runtime.

W

ARNING: 

Switch off the projector and unplug the power cord before starting the procedure.

C

AUTION: 

Never use the projector with removed filters !

Necessary parts

New filter (available kit : R9899730, contains 4 high density filters)

C

AUTION: 

Never clean the filter Always replace with a new one.

How to change the filter in the Right side.

1.  Loosen the six screws on the projector right side cover.