Product manual network audio encoder / decoder with i/o for professional and broadcast applications document version 01.02 release date 29. June 2012 hardware rev. 1.6 © 2012 barix ag, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong to their ...
Table of contents table of contents..........................................Iii introduction.......................................................1 about this document ......................................................................1 about the exstreamer 1000 ...................................
Mechanical information................................7 dimensions...........................................................................................7 weight.....................................................................................................7 mounting...........................
Introduction this product manual aims at giving insight of detailed technical aspects of the device and complements the information given in the product sheet. The barix exstreamer 1000 is a versatile network device that can function either as an audio encoder or decoder for a variety of high qualit...
Hardware the barix exstreamer 1000 consists of a motherboard with connectors and peripheral circuits supporting the embedded ip audio module “ipam 100”. In this chapter we will explain the functional blocks using the below block diagram starting on the top left and working down each interface to the...
Analog to digital converter (adc) is used and the i2s signal is then fed into the ipam 100 for encoding. For all other sampling rates the audio signal is converted by the ipam 100. The connector j8 is a standard female usb socket connected directly to the ip audio module, intended for plugging in ex...
Connectors for connector placement please refer to the below photograph of the devices front and rear side. A extension port (standard usb type a socket) memory extension port for use with standard usb memory sticks a b c d e f g h i/o 1&2 (6 pin screw terminal block plug) 1 2 3 4 5 6 pin descriptio...
Analog audio in & out (dsub 9 pin female) 5 4 3 2 1 9 8 7 6 pin description 1 left out+ [hot] 2 left out- [cold] 3 ground [g] 4 right in+ [hot] 5 right in- [cold] 6 right out+ [hot] 7 right out- [cold] 8 left in+ [hot] 9 left in- [cold] aes/ebu in & out (dsub 9 pin female) 5 4 3 2 1 9 8 7 6 pin desc...
Mechanical information the barix exstreamer 1000 aluminum enclosure measures 216 x 38 x 125 mm (width, height, depth) / 8½” x 1½” x 5”. The three d-sub 9 pin connectors stand out approximately 5 mm (audio) and 6 mm / ¼” (rs-232) and therefore increase the overall depth to 131mm / 5¼”. The barix exst...
Technical data lantronix dstni-ex,12-125mhz clock software selectable, 256 kb zero wait state static ram, 1mb flash rom (approximately 700kb available for user data), 2kb eeprom for configuration micronas mas3587f encoding features: • pcm 16bit linear @ 8 to 48 khz sampling rate • pcm 8bit logarithm...
Standard aes/ebu input with 0.2 vpp sensitivity (6.8 vpp max). Standard aes/ebu output providing typically 5 vpp signal into 110 ohm load. Standard rs-232 and rs-485 serial interfaces: parameter rs-232 rs-485 signals rxd, txd, rts, cts, gnd a, b, reference, shield baud rates 300 .. 230400 300 .. 230...
2010 barix ag, zürich, switzerland. All rights reserved. All trademarks belong to their respective owners and are used for reference only. Barix and barix ip audio module are trademarks of barix ag, switzerland and are registered in certain countries. Newest information about our devices is availabl...
