BARIX Exstreamer 500 Install Manual

Page of 4

Download

Bookmark us

EXSTREAMER

500

Quick Install Guide

Version 2.0

Mulitformat IP Audio En-/Decoder

Package contents

a Exstreamer 500

b Power supply

c Y-Cable Analog (DSub9 M to 2 x XLR M & 2 x XLR F)

d Connector set (screw terminal blocks: 2 x 6 pin, 4 pin)

Firmware

This device comes preloaded with standard firmware.

Alternative firmware can be downloaded from www.barix.com.

Support

For support please contact your local dealer or visit www.barix.com.

to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland,

and are registered in certain countries.

Page 1
Exstreamer 500 quick install guide version 2.0 mulitformat ip audio en-/decoder package contents a exstreamer 500 b power supply c y-cable analog (dsub9 m to 2 x xlr m & 2 x xlr f) d connector set (screw terminal blocks: 2 x 6 pin, 4 pin) firmware this device comes preloaded with standard firmware. ...
Page 2
Front view a reset button a brief press of the button will reset the device. Holding the reset button pressed in for approximately 10 seconds will reset the device and restore the factory default settings when the button is released. B ext. Usb interface solely for flash memory sticks (not supplied)...
Page 3
1 installation step 1 plug a standard (straight) network cable into the network port (i) of the exstreamer and the other end into your hub or switch. You can also use a crossover network cable for a direct connection to your pc. Step 2 i) if you are ready to connect to audio equipment: plug the y-ca...
Page 4
3 setting temporary ip address using arp command this procedure will work only in a local network. After this procedure the temporary ip will be active only until restart/reboot. After a restart the procedure has to be repeated. Step 1 either use a network cable to link the exstreamer and the pc dir...