BARIX Extreamer 100 Quick Install Manual

Page of 4

Download

Bookmark us

EXSTREAMER

100

Quick Install Guide

Version 2.0

Mulitformat IP Audio Decoder

Package contents

Exstreamer 100

b Power supply

RCA Stereo cable

Cable Set AUDIO (not included)

d Earphone

RCA Stereo cable

Network cable

g Serial cable

Firmware

This device comes preloaded with standard firmware.

Alternative firmware can be downloaded from www.barix.com.

Support

For support please contact your local dealer or visit www.barix.com.

to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland,

and are registered in certain countries.

Page 1
Exstreamer 100 quick install guide version 2.0 mulitformat ip audio decoder package contents a exstreamer 100 b power supply c rca stereo cable cable set audio (not included) d earphone e rca stereo cable f network cable g serial cable firmware this device comes preloaded with standard firmware. Alt...
Page 2
Front view a reset button a brief press of the button will reset the device. Holding the reset button pressed in for approximately 10 seconds will reset the device and restore the factory default settings when the button is released. B ext. Usb interface solely for flash memory sticks (not supplied)...
Page 3
1 installation step 1 plug a standard (straight) network cable (f, not included) into the network port (g) of the exstreamer and the other end into your hub or switch. You can also use a crossover network cable (not included) for a direct connection to your pc. Step 2 i) plug standard headphones or ...
Page 4
3 setting temporary ip address using arp command this procedure will work only in a local network. After this procedure the temporary ip will be active only until restart/reboot. After a restart the procedure has to be repeated. Step 1 either use a network cable to link the exstreamer and the pc dir...