Operating manual barnant/ponndorf hose pumps ponndorf pk hose pump model numbers: pk15, 25, 40, 50, 65 cole-parmer instrument co. 1-800-masterflex (627-8373) (u.S. And canada only) 11 (847) 549-7600 (outside u.S.) • (847) 549-7600 (local) • www.Masterflex.Com barnant company 1-800-637-3739 (u.S. And...
2 barnant/ponndorf table of contents title page safety precautions ............................................................................................................3 safety .......................................................................................................................
Barnant/ponndorf 3 safety precautions safety these instructions contain basic recommendations that should be followed during installation, set up, operation and maintenance. Therefore, these operating instructions must be read by the installer, operators, and other personnel before assembly and oper...
Barnant/ponndorf 4 safety instructions for maintenance, inspection, and assembly g the customer must ensure that all maintenance, inspection, and assembly are carried out by fully trained personnel who have read fully and familiarized themselves with the operating manual. G as a basic rule, the pump...
Barnant/ponndorf 5 introduction ponndorf hose pumps are self-priming rotating positive-displacement pumps without seals or valves. The liquid comes into contact with only the interior of the hose and not with the moving parts of the pump. This makes them particularly suited to pumping aggressive, ab...
Customers who purchase only the pump head are responsible for selecting the proper motor, coupling, and coupling guard and for assuring proper alignment of the motor shaft, coupling, and pump shaft. The casing material of the pump is aluminum alloy, and the baseplate material is steel. Pk series hos...
7 barnant/ponndorf reference dimensions (for gearmotor and variable speed drive models; in inches): * gearmotor version ** variable-speed belt drive version m 1 m 2 b c c od e f g h n j i l ok ** * a b c d e f g h pk15 16.54 14.96 13.66 .433 7.56 16.32 6.10 9.13 pk25 23.62 22.05 18.50 .551 9.25 22.0...
Installation and setup mechanical connection the inside diameter of the suction and discharge hoses should be approximately 25% greater than that of the pump hose. The nominal pump hose diameter is determined by the pump type. For example, a pk15 pump uses a hose with a nominal diameter of 15 mm. Th...
9 barnant/ponndorf warnings: keep hair, gloves, loose clothing, jewelry, and fingers away from openings and moving parts. The casing cover must be in place, and hands must not be put into the pump casing, unless the drive is stopped and the power is disconnected. 4) the hose comes out of the pump au...
The pump is now ready for operation. Warnings: before operating the pump, all valves in the pipe work must be opened. If this is not done, a hazardous bursting condition could develop and/or excessive pressure could damage the pump and hose and may cause harm to personnel. Adjustment of discharge pr...
11 barnant/ponndorf shim insertion/removal is achieved as follows: warning: the casing cover must be in place, and hands must not be put into the pump casing, unless the drive is stopped and the power is disconnected. Maintenance / repair cleaning when pumping materials that are likely to leave depo...
Transport and storage cautions: when lifting the pump system or a component of the pump system, the proper attachment points and lifting equipment must be used. The lifting equipment must have an adequate weight rating and the proper attachment points must be utilized to prevent failure of the lift ...
13 barnant/ponndorf warranty use only recommended hoses and replacement parts with ponndorf pumps to ensure optimum performance. Use of hoses or parts, other than the manufacturer’s authorized replacement parts, may void applicable warranties. This product is warranted against defects in material or...
