Barnstead F62730 Operation Manual - page 27

rmP.U: Setting Ramp Units

Ramp units are time units which are used in “rmP.r” seg-

ments (ramp to a setpoint at degrees per second, minute

or hour) and “rmP.t” segments (ramp to setpoint in a spe-

cific amount of time). See “Setting the Segment Type” for

an explanation on how to set a ramp segment.

1.

Press the PAGE button until you reach the pro-

gram list (ProG LiSt).

2.

Press the SCROLL button until display reads,

“rmP.U.”

3.

Press the UP or DOWN button to toggle

between seconds, minutes and hours.

dwL.U: Setting Dwell Units

Dwell units are time units which are used in “dwELL” seg-

ments (amount of time to remain at a specific tempera-

ture). See “Setting the Segment Type” for an explanation

on how to set a dwell segment.

1.

Press the PAGE button until you reach the pro-

gram list (ProG LiSt).

2.

Press the SCROLL button until display reads,

“dwL.U.”

3.

Press the UP or DOWN button to toggle

between seconds, minutes and hours.

CYC.n: Setting the Number of Cycles

Set the number of times a group of segments or pro-

grams are to be repeated by following the steps listed

below.

1.

Press the PAGE button until you reach the pro-

gram list (ProG LiSt).

2.

Press the SCROLL button until display reads,

”CYC.n.”

3.

Press the UP or DOWN button to select the

number of cycles you want to run or, press the

DOWN button to select “cont.” so the program

will run continuously.

8 S

EGMENT

P

ROGRAMMABLE

M

ODEL W

/OTP

27