Barnstead FB1310M Operation And Repair Manual And Parts List - page 13

13

S

INGLE

S

ETPOINT

C

ONTROLLER

Atun List

tunE:

One-shot autotune enable.

Pid List

Pb:

Proportional band (in display units).

ti:

Integral time in seconds.

td:

Derivative time in seconds.

ACCS List Code:

Access code (Code need-

ed to enter or change the other configuration

parameters which are not normally accessi-

ble.) Not accessable.

Alarms

The controller will flash an alarm message in

the home display if an alarm condition is

detected.

2FSH:

Measured value full scale high alarm.

IdHi:

Measured value deviation high alarm.

S.br:

Sensor break: check that sensor is con-

nected correctly.

L.br:

Loop break: check that the heating cir-

cuits are working properly.

Ld.F:

Heater Circuit fault: indication of either

an open or short solid sate relay, a blown

fuse, missing supply or open circuit heater.

Note

The following alarm messages

are factory default settings and

may vary if you have changed

the configuration of your 

controller:

IDHi: = 50°C

2FSH = 1125°C