- 1 - 104.025 / 104.040 bedienungsanleitung eiswürfelbereiter seite 3 bis 15 instruction manual ice cube maker from page 17 to 29 mode d’emploi machine à glaçons de page 31 à page 43 d/a/ch gb/uk f/b/ch v3/0312.
- 17 - 1. General information 18 1.1 information about the instruction manual 18 1.2 key to symbols 18 1.3 liability and warrantees 19 1.4 copyright protection 19 1.5 declaration of conformity 19 2. Safety 20 2.1 general information 20 2.2 safety instructions for the use of the device 20-21 2.3 inte...
- 18 - 1. General information 1.1 information about the instruction manual this instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructi...
- 19 - 1.3 liability and warrantees all the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due ...
- 20 - 2. Safety this section provides an overview of all important safety aspects. In addition every chapter provides precise safety advice for the prevention of dangers which are highlighted by the use of the above mentioned symbols. Furthermore, attention should be paid to all pictograms, markers...
- 21 - caution! O the unit is not intended for use by individuals (including children) with physical or mental disabilities, insufficient experience, and/or insufficient knowledge unless such persons are under the care of a person responsible for their safety or have received instructions regarding ...
- 22 - 3. Transport, packaging and storage 3.1 delivery check please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Note the extent of damage on the carrier’s bill of delivery....
- 23 - 4. Technical data 4.1 technical specifications description ice cube maker item no.: 104.025 104.040 model: c 25 c 40 cooling agent: r134a / 130 g r134a /200 g connected load: 230 v ~ 50 hz power: 220 w 380 w ice cube production: approx. 25 kg / 24 std. (cone shape) approx. 35 kg / 24 std. (co...
- 24 - 4.3 features - air cooling - paddle system - electronically controlled compressor - light sensor controlled ice cube production - with water supply and outlet 5. Installation and operation 5.1 safety instructions warning! Electrical hazard! The device must only be connected to a properly inst...
- 25 - warning! Hazard via electrical current! The device can cause injuries due to improper installation! Before installation the local power grid specification should be compared with that of the device (see type label). Connect the device only in case of compliance! Take note of the security advi...
- 26 - • attach one end of the drainage hose using the rubber drainage cuff at the rear of the unit. Attach the second end to a sewage outlet or water container. The sewage outlet or water container must be situated lower than the ice cube maker, so that water flows out. 5.3 operating • before first...
- 27 - 6. Cleaning and maintenance 6.1 safety advice o before beginning with repair or cleaning works make sure the device has been disconnected from power socket (pull the power plug!!!) and has cooled down. O do not use any acid agents and make sure no water ingresses the device. O to protect your...
- 28 - 7. Possible malfunctions problem possible cause solution device does not function. • device is switched off • power supply is interrupted • ambient temperature is below 10°c • switch on the device • check the power supply • see that an ambient temperature of more than 10°c is provided. The co...
- 29 - 8. Waste disposal discarding old devices at the end of its service life the discarded device has to be disposed in accordance with the national regulations. It is advisable to contact a company which is specialized in waste disposal, or just contact the local disposal service in your communit...
