Bartscher FW 80 Operating Instructions - Components
- 8 -
Components
Universal mincer attachment (A)
1.
Locking ring
2.
Plate
3.
Knife
4.
Worm
5.
Housing
6.
Pusher
7.
Funnel feeder
Motor unit (B)
8.
Carrying handle
9.
Power indicator light
10.
ON/OFF switch
11.
Fixing screw
12.
Power cord
13.
Identification plate
14.
Overload safety switch
Before Using
Clean all parts before first use (see chapter
cleaning).
Assembling
Push the worm (4) into the housing (5).
Put the knife (3) with the cutting edges
looking outside the housing onto the worm.
Assembling (cont.)
After that assemble the plate (2) regarding
the notch is corresponding with the pin at
the housing.
Then fasten the locking ring (1).
Insert the universal mincer attachment onto
the motor unit. Locate it properly by a light
reciprocating turning until the pin engages
onto the groove at the motor unit. Only then
tighten the fixing screw (11).
At least add the funnel feeder (7) and keep
the pusher (6) ready.