- DL manuals
- Bartscher
- Indoor Fireplace
- GWH2 / 105210
- Translation Of The Original Instruction Manual
Bartscher GWH2 / 105210 Translation Of The Original Instruction Manual
Summary of GWH2 / 105210
Page 1
0051 cn 4225 v2/0415 gwh3 / 1053103 gwh2 / 1052103.
Page 2: Gb/uk
- 29 - english translation of the original instruction manual table of contents 1.Safety ........................................................................................................................ 30 1.1 safety instructions ..................................................................
Page 3: 1.Safety
- 30 - read these instructions before using and keep them available at all times! This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety in...
Page 4: 1.2 Key To Symbols
- 31 - • to prevent hazards and to ensure optimum efficiency, no modifications or alterations to the device that are not explicitly approved by the manufacturer may be undertaken. • before cleaning and maintenance of the device and if not using the device for an extended period of time, disconnect t...
Page 5: 1.3 Hazard Sources
- 32 - 1.3 hazard sources danger! In order to avoid any danger from gas please follow the safety instructions listed below. Do not use the device if it is not operating properly, has been damaged or dropped. Incorrect installation, maintenance, cleaning or any modifications to the device may cause s...
Page 6: 1.4 Intended Use
- 33 - warning! Risk of fire or explosion! In order to avoid this risk please follow the instructions listed below. Do not leave the device unattended when heating fats or oils, because they may combust spontaneously. Do not place any flammable objects near the device. Never put out the flames or fi...
Page 7: 2. General Information
- 34 - 2. General information 2.1 liability and warrantees all the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was t...
Page 8: 3.1 Delivery Check
- 35 - 3. Transport, packaging and storage 3.1 delivery check please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Note the extent of damage on the carrier’s bill of delivery....
Page 9: 4. Technical Data
- 36 - 4. Technical data 4.1 technical specification description gas wok cooker gwh2 code-no.: 1052103 material: chs 18/10 no. Of burners/power 2 of 11.5 kw gas connection: r 3/4" gas pressure at connection: g 30/g 31 : 28 – 30/37 mbar g 30/g 31 : 50 mbar g 20 : 20 mbar g 25 : 25 mbar rated heat loa...
Page 10
- 37 - description gas wok cooker gwh3 code-no.: 1053103 material: chs 18/10 no. Of burners/power 3 of 11.5 kw gas connection: r 3/4" gas pressure at connection: g 30/g 31 : 28 – 30/37 mbar g 30/g 31 : 50 mbar g 20 : 20 mbar g 25 : 25 mbar rated heat load: natural gas: 39 kw, liquid gas: 34.5 kw dim...
Page 11: 4.2 Overview Of Parts
- 38 - 4.2 overview of parts 1052103 / gwh2 fig. 3 ① burner ⑤ feet of adjustable height ② round wok insert ⑥ base with shelf ③ cooking station knob ⑦ base ④ tray for dripping fat ⑧ cooker housing ① ④ ⑦ ⑧ ② ⑤ ⑥ ③.
Page 12
- 39 - 1053103 / gwh3 fig. 4 ① burner ⑤ feet of adjustable height ② round wok insert ⑥ base with shelf ③ cooking station knob ⑦ base ④ tray for dripping fat ⑧ cooker housing ① ③ ④ ⑦ ⑧ ② ⑤ ⑥.
Page 13
- 40 - features of gas wok cookers • high-efficient burner of power of 11.5 kw, manual ignition • burners removed without tools • burners with thermoelectric protection • dripping fat collecting tray under the burners • base with adjustable feet • preset to liquid gas, natural gas jets are enclosed ...
Page 14
- 41 - fig. 6 the information plate shows warning information in the languages of target countries. De dieses gerät muss nach geltenden vorschriften angeschlossen und darf nur in einem gut belüfteten raum betrieben werden. Bitte beachten sie vor inbetriebnahme des gerätes die gebrauchs- und wartungs...
Page 15
- 42 - 5. Installation and operation 5.1 instructions for the installer caution! Any installation, connection and maintenance work related to the device must be performed by the qualified gas installer, according to the international, national and local regulations in force in the installation count...
Page 16
- 43 - 5.1.1 a ssembly of the lower section fig. 8 a. Place 4 pipes on the lower storage surface. Use external toothed washers, washers and nuts m8. B. Put the stabilizer strips on the upper tips of pipes (2 strips on the sides, 1 strip in the front and 1 strip in the back). Use external toothed was...
Page 17
- 44 - 5.1.2 installation • do not install the device in toxic or explosion-threatened environment. • do not install the device in the vicinity of flammable materials, like gasoline, glue, liquid gas, paper, etc. • do not install the device in wet or humid room or conditions, like in the rain or nex...
Page 18
- 45 - 5.1.3 gas connection gas supply connection • before the installation and connection to the gas supply carefully check the permanent part of the gas device which should conform to the national building regulations. • check if the cross section of pipes assures sufficient supply for all gas-pow...
Page 19
- 46 - control of gas pressure and rated heat load (fig. 9) • during the first installation the installer must check the rated heat load of the device and if necessary introduce appropriate changes or modify the device for a different type of gas. • do not attempt to increase the rated efficiency or...
Page 20
- 47 - table 1: inlet pressure gas type inlet pressure (mbar) normal minimum value maximum value natural gas g20 20 18 25 liquid gas g 30/g 31 50 42.5 57.5 table 2: use of gas categories and pressures in various countries caution! The device operates correctly only when the pressure in the gas line ...
Page 21
- 48 - country categories gas type gas pressure (mbar) ie ireland ii 2h3+ g20 - g30/g31 20 - 28-30/37 is iceland i 3b/p g30/g31 30/30 it italy ii 2h3+ g20 - g30/g31 20 - 28-30/37 lt lithuania ii 2h3+ ii 2h3b/p g20 - g30/g31 g20 - g30/g31 20 - 28-30/37 20 - 30/30 lu luxemburg i 2e g20 20 lv latvia ii...
Page 22
- 49 - • the modification must be performed by the qualified gas installer only, according to the technical data, by replacement of the nozzle in the main burner and adjustment of the nozzle in the ignition burner. Replacement of the nozzle in the main burner (fig. 10) fig. 10 a) remove the burner r...
Page 23
- 50 - adjustment of primary air (fig. 11) the primary air is adjusted and sealed permanently according to the country of destination and type of gas. The adjustment data are shown on the package and the rating plate. If the modification is required, adjust the primary air according to the table 3 „...
Page 24
- 51 - adjustment of the ignition flame (fig. 12) fig. 12 after modification of the device for the natural gas, adjust the ignition flame. Please follow the instructions listed below. A) ignite the gas burner according to the instructions in section 5.2.2 „first start-up” b) with the use of 11mm ope...
Page 25
- 52 - 5.2 instructions for the user caution! Carefully read the manual below as it includes the safety and operation instructions. Store the operation manual for later reference. Incorrect installation, operation, maintenance and any modifications may lead to improper operation, damages and injurie...
Page 26
- 53 - 5.2.2 first start-up cooking station knob fig. 13 switching the gas wok cooker on / off - switching the burner on a. Open the gas shut-off valve to start the gas supply. B. Rotate the knob to the ignition position , press and hold it, then ignite the flame with the lighter. Hold the knob pres...
Page 27
- 54 - 6. Cleaning and maintenance caution! The device is not designed for direct washing with the water jet. Do not use water stream for cleaning! Cleaning o clean the device periodically in order to keep it ready for work and prolong its life span. O perform the regular cleaning as listed below an...
Page 28: 7. Possible Failures
- 55 - 7. Possible failures before contacting the service check the possible failures in the table below. Failure cause solution the ignition flame does not start • blocked gas pipe to the ignition burner • blocked ignition burner • blocked ignition head • blocked ignition nozzle • check and remove ...
Page 29
- 56 - 8. Removing of waste material the worn out device should be removed according to the national and local regulations. To do this, contact the professional company or with the waste removing department of the local authorities. Caution! In order to exclude the incorrect use and connected danger...