Base Line BL-ETH-SW Installation Manual - Bl-Eth-Sw Ethernet Switch
BL-ETH-SW Ethernet Switch
Pedestal Installation Guide
1-866-294-5847
Rev 10042016
www.baselinesystems.com
Power Connector Instructions
1. Locate the 5-pin splitter that is included with the Ethernet
switch.
2. Inside the pedestal, locate the pair of 5-pin connectors
on the upper end of the control board.
Note: The photo below shows the dust cover removed
from the control board. You may not need to remove the cover to access the 5-pin
connectors.
3. Carefully remove the plug from the lower
connector.
4. Attach the 5-pin splitter onto the lower
connector.
5. Attach the plug that you removed from the
control board onto one of the connectors on
the 5-pin splitter.
6. Attach the end of the power cord from the
Ethernet switch to the other connector on the
5-pin splitter.
7. Attach the 3’ Ethernet patch cable to the
Ethernet switch and to the back of the
controller display.
8. Attach an Ethernet cable to the communication module (such as a cell modem gateway or
Ethernet radio) and to one of the ports on the Ethernet switch. Repeat this step for any
additional communication modules.
9. In another Ethernet port, connect an Ethernet cable to the Ethernet wall jack, if needed.
10. Reconnect the orange power connector to the board in order to restore power to the
controller.
11. Verify that the LEDs on the communication module(s) are illuminated.
12. Close the enclosure door, and then restart the controller.