Baseline 12-1190 Instruction Manual - Parameters.
to your Height level. Press ‘■’ button to confirm setting. LCD will
prompt to next parameter setting (Age).
IV. Press Up/Down Arrow (▲▼) button to advance / reverse to ad-
just to your Age. Press ‘■’ button to confirm setting. LCD will
prompt back to Memory setting. all settings are complete!!!
at this point, you can continue to press ‘■’ button a few
times to cycle through the setting mode to review all
parameters.
V. Press ‘►’ button to exit setting mode and enter normal Fat Mon-
itor operating mode. LCD will read ‘0.0 kg’ or ‘0.0 lb’. You are
ready to weigh yourself, and let the scale compute your Fat and
Hydration percentage.
2. Step on the scale barefoot. Make sure your feet are clean and dry.
This gives the weighing platform the best conductive effect. While
stepping on scale, place your feet on the metal conductive pads.
Stand with feet apart to avoid short circuit.
If the LcD auto-Off appears before you step on the scale, sim-
ply press the ‘■’ button again, wait a short period of times and
the LcD will show your current settings. then press ‘►’ button
again to re-enter normal operation mode.
3. As soon as you step on the scale, LCD will immediately display in-
crementing digits until it stabilizes, locks & flashes, indicating your
current weight.
4. Within a few seconds, the scale will automatically compute your Fat
and Hydration percentages. LCD will show your Fat% (icon “BF”)
followed by Hydration% (icon “BW”). Subsequently, LCD will flash
back and forth alternatively between value of Fat and Hydration per-
centages for 5 times, and then automatically shut down.
along the lower edge of the LcD, you will see a key line of mul-
tiple vertical bars. this key line serves to give an indication of
your fat% level, telling where your fat level standing is com-
pared to the statistics norms and whether you are considered
underweight, normal, or overweight. this information is for ref-
erence only. If it causes concern, see your doctor.
nOtE: Whenever you turn the unit on for a fresh operation, you
can always go through the same steps from ILLuStratIOn 1
(I) to (V) to verify or adjust all personal data and previous meas-
ured records, before measuring for new records.
5