BassBoss DJ112 Owner's Manual - page 7
Page 7
SET UP INSTRUCTIONS
1. Place loudspeaker in the desired location. Ensure that it is secure and stable.
2. Rotate the input attenuator knob counterclockwise to the lowest setting.
3. Connect signal via the XLR input jack.
4. Connect the amplifier module’s power supply cord using the blue PowerCon™ connectors.To insert, align the indexing tabs on the
Powercon™ connector, insert it into the socket and rotate clockwise until the latch catches.
5. Connect the electrical plug to a power source.
6. Select the desired preset via the PGM SEL button.
7. Rotate the input attenuator clockwise to achieve the desired sound level.
The DJ112 compact monitor loudspeaker’s DSP is supplied with 4 presets. All four presets contain limiter settings to ensure safe operation of
the unit.The presets are accessed in sequence via the preset select button on the rear of the unit.A green LED indicates the active preset. The
level knob provides a range of control from OFF to +12dB within each preset.
The presets are described as follows:
Preset 1: Warm/Near-field setting featuring HF output attenuated to -4dB
Preset 2: Warm/intermediate distance setting featuring HF output attenuated to -2dB
Preset 3: Flat response setting
Preset 4: Far-field setting featuring HF output elevated to +2dB
System Setup Addendum:
When connecting multiple loudspeakers in a system, signal can be passed through from one loudspeaker to another using XLR cables. No
processing is applied to the signal as it passes through from the input to the output connectors in each loudspeaker. Signal can be routed in
any sequence because each loudspeaker receives a full-range signal and applies the necessary processing in order to operate as part of the
overall system. It is recommended to run signal to the nearest box first and patch to the next nearest box in sequence. It is recommended to
run the DJ112 as the last box in the sequence when it is mounted on a pole or tripod stand.
TROUBLESHOOTING
If after following the above instructions for setup you have no output from the loudspeakers, please check the following:
Verify that the green power (PWR) LED is on. If not, check the following:
1. Is the power cord plugged into a live outlet?
2. Is the Neutrik Powercon connector rotated into the locked position?
If the power LED is on, check the following:
Is the green “signal present” LED (SIG) illuminating? If not:
1. Is the signal cable connected to the input?
2. Is the signal cable connected to an operating output at the other end?
3. Is the signal flowing to the input? Check the integrity of the cable.