Batavia BT-CS009 Operating Instructions Manual - page 38
English
36
.
TROUBLESHOOTING
Symptom
Possible Causes
Possible Solution
Tool will not start when
operating the on/off switch.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn
down.
Check to make sure power
cord is connected well into a
working outlet.
Unplug the power cord.
Replace it by a qualified
maintenance person.
Replace the carbon brush by
a qualified maintenance
person.
Cutting depth is less than that
is set.
Sawdust accumulated,
blocking the base.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Blade spins or slips
Blade is not tightly engaged
with the spindle.
Remove the blade, and
reassembled it as described
in install /change the Blade
section.
Blade will not cut a straight
line.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Mount a new, sharp blade on
the saw.
Check that blade is properly
mounted.
Use and edge guide.
7062244_MaxxSaw_Ma_#1503-19.indb 36
09-04-15 11:31