- DL manuals
- Bauer
- Engine
- MSXH
- Operating Manual
Bauer MSXH Operating Manual - 5 Electrical Connection
Operating Manual for BAUER Submersible Motor Mixer / Version l-2013
15
5 ELECTRICAL CONNECTION
The electrical connection must imperatively be carried through by an approved electrician. The three-
phase motor is protected from phase failure, low voltage and overloading by the thermal coil protection (PTC
thermistors) together with the tripping device. Upon request, Bauer supplies fully wired electrical control units
ready for connection. Weatherproof installation of the electrical control is recommended (inside a building or under
a weather-proof hood at the manure tank).
All mixers are equipped with an 8 m long electric cable (cable Ø 20 mm). The cable connection to the motor must
not be dismounted!
Fix the electric cable to the traction rope by means of a stainless bolt-snap, which enables the cable to follow
automatically lifting and lowering movements of the mixer. Attach the cable to the rope by means of the provided
rope strap about 1 m above the upper edge of the console (see drawing) in order to prevent the cable loops from
getting into the mixing propeller when lifting the mixer. Attach the upper-most bolt-snap to the backing plate.
Check cable length to make sure the cable is not under traction when the mixer is completely lowered! Take care
to place the cable in wide loops in order to prevent it from folding.
Summary of MSXH
Page 1
Operating manual for submersible motor mixer msxh version: i - 2013.
Page 2
Operating manual for bauer submersible mixer/ version i-2013 2 introduction thank you very much for purchasing a bauer submersible motor mixer! We take pleasure in presenting to you a bauer submersible motor mixer that features state-of-the-art technology and top quality. This manual describes how t...
Page 3
Operating manual for bauer submersible motor mixer / version l-2013 3 product details type designation: submersible motor mixer type number: msxh serial number 1 : dealer: name: address: tel./fax: date of delivery: manufacturer: röhren- und pumpenwerk bauer ges.M.B.H. Kowaldstr. 2 a - 8570 voitsberg...
Page 4
Operating manual for bauer submersible mixer/ version i-2013 4 general safety instructions symbols and terms the ce symbol that has to be affixed on the machine by the manufacturer outwardly demonstrates compliance of the machine with the directives for machines and other relevant eu directives. Thi...
Page 5
Operating manual for bauer submersible motor mixer / version l-2013 5 product liability as defined by the product liability law every farmer is also an entrepreneur! According to §9 phg (product liability law), liability for damage to corporal things caused by defective products is expressly exclude...
Page 6: Index
Operating manual for bauer submersible mixer/ version i-2013 6 index 1 general instructions for safety and accident prevention .......................................... 7 2 general .........................................................................................................................
Page 7: Accident Prevention
Operating manual for bauer submersible motor mixer / version l-2013 7 1 general instructions for safety and accident prevention check the machine for operational safety before every start-up. 1. In addition to the instructions contained in this manual, all specifications generally valid for safety a...
Page 8
Operating manual for bauer submersible mixer/ version i-2013 8 9. Mounted or trailed machines as well as balancing weights influence road behaviour, steering and braking capacity. Therefore make sure that proper steering and braking are possible! 10. Consider the projection and/or centrifugal mass o...
Page 9
Operating manual for bauer submersible motor mixer / version l-2013 9 power take-off (applies only to pto driven machines) 1. It is not allowed to use any other types of pto drive shafts except those prescribed by the manufacturer! 2. Drive shaft guard tube and guard cone as well as the pto guard – ...
Page 10
Operating manual for bauer submersible mixer/ version i-2013 10 hydraulic system 1. Hydraulic system is under high pressure! 2. When connecting hydraulic cylinders and motors, make sure the hydraulic hoses are connected as specified! 3. Before coupling the hydraulic hoses with the tract or’s hydraul...
Page 11
Operating manual for bauer submersible motor mixer / version l-2013 11 hand-operated devices (valves) 1. Because of the slurry gasses produced in the lines, no slurry is allowed to remain in closed pipelines – bursting hazard! 2. Lay the pipelines with sufficient inclination and make sure that the s...
Page 12: 2 General
Operating manual for bauer submersible mixer/ version i-2013 12 2 general bauer products are designed and manufactured carefully and subject to a system of continuous quality control. The submersible motor mixers fully meet the requirements of the agricultural practice and of biogas plants. They are...
Page 13: 4 Mounting Instructions
Operating manual for bauer submersible motor mixer / version l-2013 13 4 mounting instructions 4.1 mounting of guide tube and guide tube bracket slip the guide tube bracket over the guide tube and secure it at the silo edge / pit cover. Use a level to bring the guide tube into vertical position. Set...
Page 14
Operating manual for bauer submersible mixer/ version i-2013 14 4.3 mounting of mixer put the rope over the rope pulleys and attach its thimble at the mixer console. Use the winch to bring the mixer into a position under the guide tube bracket and secure the guide console at the bottom, behind the g...
Page 15: 5 Electrical Connection
Operating manual for bauer submersible motor mixer / version l-2013 15 5 electrical connection the electrical connection must imperatively be carried through by an approved electrician. The three- phase motor is protected from phase failure, low voltage and overloading by the thermal coil protection...
Page 16: 6 Putting Into Operation
Operating manual for bauer submersible mixer/ version i-2013 16 6 putting into operation when the motor mixer is put into operation for the first time make sure the supply voltage complies with the voltage specified on the motor nameplate. Before connecting the motor check the phase sequence for the...
Page 17
Operating manual for bauer submersible motor mixer / version l-2013 17 6.1 manual operation 6.1.1 control box components three contactors with timer for star-delta starting motor protection devices: motor protective relay for current monitoring thermistor tripping relay for temperature monitoring 6....
Page 18
Operating manual for bauer submersible mixer/ version i-2013 18 6.1.6 malfunctions the red key is lighting up: the motor protection system has turned off the motor. Find the cause of the malfunction and remedy it. The light of the red key goes out. The motor cannot be started: check power supply: is...
Page 19
Operating manual for bauer submersible motor mixer / version l-2013 19 bauer control unit logo with timer for interval operation logo programming 6.2.2 initial operation of timer logo before the initial operation the control panel has to be connected correctly according to the connection diagram. Pu...
Page 20
Operating manual for bauer submersible mixer/ version i-2013 20 confirm with key cursor down ▼ ( 2 times ), then set cursor > to set confirm with key ok (1 time ) the display is showing the following confirm again with the key ok (1 time) the display is showing the following confirm again with the k...
Page 21
Operating manual for bauer submersible motor mixer / version l-2013 21 b 9 weekly clock timer every weekly clock timer has three cams for adjusting (b9 / 1,2,3), where you can parameterize a time window. Set the switching point and the stop position with the cams. The weekly timer puts on the interv...
Page 22
Operating manual for bauer submersible mixer/ version i-2013 22 the display is showing the following 1.) press key ok; the cursor is on the first weekday 2.) choose one or more weekdays with the keys ▼ or ▲ 3.) move the cursor with the key ► to the next weekday 4.) repeat the procedure until you hav...
Page 23
Operating manual for bauer submersible motor mixer / version l-2013 23 the display is showing the following you can set the mixing times and pauses in the parameter b11 th = mixing time tl = pause ta = displays the present mixing times and pauses factory setting th = 10:00m tl = 05:00m ta = 00:00m a...
Page 24
Operating manual for bauer submersible mixer/ version i-2013 24 b 17 operating hour meter the current operating hours are shown on the display there is no need to set anything see operating hours : press key esc the display is showing the following confirm with key ▼ , choose „set param“ and confirm...
Page 25
Operating manual for bauer submersible motor mixer / version l-2013 25 6.3 interval operation and level control for explosive environment examinated according to certificate tÜv 03 atex 2098 x attention: electrical equipment which is to be used in potentially explosive atmosphere must imperatively b...
Page 26
Operating manual for bauer submersible mixer/ version i-2013 26 6.3.2 control elements main switch red for power supply turn-switch black for manual or interval operation reset key red for probe 1 reset key red for probe 2 6.3.3 connections power supply by means of 5-pole connecting cable directly a...
Page 27
Operating manual for bauer submersible motor mixer / version l-2013 27 6.3.6 malfunctions the red light is on: „motor malfunction″ thermistor tripping relay has responded (motor is overheating). Running mode switch is not in position “0” but in position „manual“ or „interval“ when turning the motor ...
Page 28
Operating manual for bauer submersible mixer/ version i-2013 28 the red light for probe 1 or 2 is on: (note: tripping device rda 02 has turned the motor off) turn the switch for mode of operation to 0 press reset key for about 3 seconds red light goes out – put turn switch to the required position a...
Page 29
Operating manual for bauer submersible motor mixer / version l-2013 29.
Page 30
Operating manual for bauer submersible mixer/ version i-2013 30
Page 31
Operating manual for bauer submersible motor mixer / version l-2013 31.
Page 32
Operating manual for bauer submersible mixer/ version i-2013 32.
Page 33
Operating manual for bauer submersible motor mixer / version l-2013 33.
Page 34
Operating manual for bauer submersible mixer/ version i-2013 34.
Page 35
Operating manual for bauer submersible motor mixer / version l-2013 35.
Page 36
Operating manual for bauer submersible mixer/ version i-2013 36.
Page 37: 7 Maintenance
Operating manual for bauer submersible motor mixer / version l-2013 37 7 maintenance the wire rope is made from stainless v4a material. Nevertheless check the rope regularly and do replace it if it is worn. Incidental greasing or lubricating will increase its useful lifetime. Spray the entire rope w...
Page 38
Operating manual for bauer submersible mixer/ version i-2013 38 lubrication and maintenance schedule always turn power off when changing oil or lubricating, and secure the mixer from unintentional switching on. Interval after 750 operating hours every six months after 2000 houres oil change / oil ch...
Page 39: 8 Trouble-Shooting
Operating manual for bauer submersible motor mixer / version l-2013 39 8 trouble-shooting before lifting, moving or repairing the mixer always turn off main switch and secure the device from unintentional switching on. The submersible motor mixer runs but works poorly possible causes check and repai...
Page 40: 9 Technical Data
Operating manual for bauer submersible mixer/ version i-2013 40 9 technical data power p [kw] 7,5 11 15 voltage u [v] 400 400 400 rated current i nenn [a] 15,6 22 28,6 speed n [min -1] 1450 1400 1450 cosinus phi cos phi [1] 0,81 0,84 0,86 frequency frequency [hz] 50 50 50 protection protection ip 68...
Page 41
Operating manual for bauer submersible motor mixer / version l-2013 41 wiring diagram 400 v 50 hz star- delta start.
Page 42
Operating manual for bauer submersible mixer/ version i-2013 42 wiring diagram 400 v 50 hz with 460 v 60hz running delta start.
Page 43
Operating manual for bauer submersible motor mixer / version l-2013 43 wiring diagram 480 v 60 hz delta start lifting and lowering device.
Page 44: 617 9916
Operating manual for bauer submersible mixer/ version i-2013 44 617 9916 3 0 ° 1 5 ° 499 180 80 100 1025 1154 29 330 4 4 5 6 9 8 4 4 3 300
Page 45: 617 1250
Operating manual for bauer submersible motor mixer / version l-2013 45 617 1250
Page 46
Operating manual for bauer submersible mixer/ version i-2013 46.
Page 47
Operating manual for bauer submersible motor mixer / version l-2013 47.
Page 48: 617 9920
Operating manual for bauer submersible mixer/ version i-2013 48 617 9920
Page 49
Operating manual for bauer submersible motor mixer / version l-2013 49.
Page 50
Operating manual for bauer submersible mixer/ version i-2013 50
Page 51
Operating manual for bauer submersible motor mixer / version l-2013 51.
Page 52
Operating manual for bauer submersible mixer/ version i-2013 52 10 conformity certificate ec declaration of conformity according to ec directive 2006/42/ec the manufacturer röhren- und pumpenwerk bauer gesellschaft m.B.H. Kowaldstraße 2, 8570 voitsberg, austria phone +43 3142 200-0; fax: +43 3142 20...