Bauhn AWBS-0816-S Instruction Manual - page 11
11
1300 886 649
Model: AWBS-0816-S Product Code: 54265 08/2017
www.tempo.org
AUS
Installation (Cont.)
Step 2: Preparing the Shelf Support Brackets to be attached to the Wall
Mount Bar
a) Clip the four plastic supports for the glass onto the Shelf Support
Bracket.
b) Repeat this for the second Support Bracket.
On a wood stud wall
a) Locate the edges of the studs in the wall using a commercially available
stud finder and mark the centre of the studs. Confirm the presence of the
studs by drilling a small diameter pilot hole.
b) Using the Wall Mount Bar as a template, markout then drill three holes of
4mm diameter. Ensure the holes are 60mm in depth, as illustrated above.
c) Hold the Wall Mount Bar to the wall and align the holes in the bar to the
holes drilled into the wall.
d) Screw the Wall Mount Bar to the wall with the three Self-Tapping Screws
(A).
NOTE: When you are installing the wall mount bar to a wood stud wall,
consult your builder for advice. The wall must be strong enough to
support the weight of the wall mount bar and its equipment.
E
D
F