Bauknecht GSIK 6528 Installation And Maintenance Instructions Manual
5019 496 01085
1
GB
GSIK 6528
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1)
Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra
functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2)
Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison
test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3)
The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.
1. OVERVIEW
Programme selector
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds to cancel a started
programme and selected extra functions. The main fault
indications (repeated flashing of the START indicator) can be
cancelled by RESETTING. Also refer to section 5 “What to do, in
case of...”.
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
With indication “F..”, refer to section 5 “What to do, in case of …”.
Delayed Start button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
Detergent setting at first startup and when using a different type of detergent
1. Select the third programme in the relevant table.
2. Press the START button for about 7 sec. to change the display.
3. Using the START button, set the required detergent:
The display shows: 2 -1 = 2 in 1, 3 -1 = 3 in 1, 4 -1 = other combined action
detergents (in this way, the rinse aid and/or salt indicator is deactivated).
The display shows OFF = Powder detergent (factory setting)
(rinse aid and salt indicator activated).
4. Switch the appliance off and then on again. The selected detergent will be
displayed for approx. 3 sec.
Half Load/Multizone button
Only load the top rack or bottomrack.
Press once = wash top rack (the indicator/symbol lights up)
Press twice = wash bottom rack (the indicator/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the top rack, press the “Half load” (i.e. “wash
bottom rack”) button twice; the corresponding indicator/symbol
lights up.
Antibacterial rinse
3)
This function activates an antibacterial rinse ensuring a further
reduction of bacteria. Press the button to activate or deactivate
this function and the appropriate programmes are indicated with
the corresponding symbol in table 1.1.
The dishwasher door must remain closed for the entire duration
of the programme, to ensure the reduction of bacteria. If the door
is opened the indicator starts flashing.
On / Off Button
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable
extra
functions
Loading instructions
large
small
Litres
kWh
Minutes
1
Auto Sensor
50-65°C
Recommended programme for
daily use, with dry food residuals
(e.g. EN 50242).
X
X
11-16
1.10-1.50
100-130 ±
1)
2
Pre-Rinse
cold
Dishes to be washed later.
—
—
4.0
0.03
14 ±
1)
3
Quickwash
40°C
Slightly dirty dishes, without
dry residuals.
X
—
10.0
0.65
30 ±
1)
4
Bio Normal
2)
50°C
Normally dirty dishes.
Energy-saving programme.
X
X
12.0
1.05
165 ±
1)
5
Intensive
70°C
Recommended programme for
very dirty dishes, particularly
suitable for pots and pans.
X
X
14.0
1.55
155 ±
1)