BIONIME Rightest GM550 Getting Started Manual
3
GM550 GETTING STARTED GUIDE
( For self-testing )
Test strips vial
Lancing Device
Lancet
Preparing the Lancing Device
Front View of Meter
Back View of Meter
Test strips
Sample Entry
View Window
Protective cover
Test Strips
1
2
3
Plunger
Hub
Lancet carrier
Release button
Safe switch
Depth adjustable cap
Left Button ( )
For operating the
meter, please check
details in following
sections.
Main Button ( )
For operating the
meter, please
check details in
following sections.
Display Window
Show your test
result, messages
and relative
information.
Test Strip Port
Insert test strip here
until you hear a
click.
Right Button ( )
For operating the
meter, please check
details in following
sections.
Product
name
Battery Cover
Slide cover to
change batteries.
Meter Serial
Number
Batteries Installation
1
1) Turn the meter over. Press and push battery cover to open.
2) Install the battery. Be sure to put battery in correct direction.
3) Slide the battery cover back until it snaps into place.
5) Repeat steps 3 and 4 to change the date, time format, hour, minute, volume, and measurement
unit. After pressing the main button to confirm the measurement unit setting, your set-up has
been finished.
2
Setting Up Your Meter - Setting the Date, Time and Unit
1) Press and release main button " " to turn on the Meter.
2) Press and hold main button " " for 7 seconds until you go into the setting mode. Before you go
into setting mode, the meter will turn off first. Please keep pressing it until you go into the setting
mode. The year will flash.
3) Press left button " " or right button " " to change the year.
4) Press main button " " to confirm the year and move to month setting.
NOTE
-
Suggest not to use this meter close to source of strong electromagnetic radiation, to avoid
interference with proper operation.
-
Suggest to keep meter free of dust, water or any liquid.
1
2
3
1) Hold the depth
adjustable cap in one hand and hold the hub in the other hand. Bend the cap
towards the down side. When a gap appears between the cap and hub, pull them off in opposite
directions.
2) Pull off the depth adjustable cap.
3) Insert a new disposable lancet firmly into lancet carrier.