BIOS W100 Instruction Manual - 2.3 Inserting The Batteries
2.3 Inserting the Batteries
Follow these steps to insert the two “AAA” batteries in the device.
1. Open the battery compartment cover in the direction shown.
2. Insert the two “AAA” batteries with the correct polarity as indicated.
3. Replace the battery compartment cover.
NOTE: Replace the batteries whenever the weak battery mark shows, the display is dim,
or the display does not illuminate when the power is on. Replace all the batteries at the
same time - it is dangerous to mix old and new batteries.
Contact your local waste disposal authority for instructions on how to dispose of used batteries.
Used batteries can be harmful to the environment, and should not be thrown out with household
trash.
3. Using the Device
This section describes how to get the maximum benefit from your Wrist Blood Pressure Monitor.
Follow the instructions carefully to get an accurate measurement of your blood pressure and pulse
rate.
3.1 Setting the Date and Time
It is important to set the clock before using your blood pressure monitor, so that the correct time
stamp can be assigned to each record that is stored in the memory.
1. After the new batteries are inserted, the year number flashes in the display. You can set the year
by pressing the M-button . To confirm and then set the month, press the time button .
2. You can now set the month using the M-button . Press the time button to confirm and then
set the day.
3. Please follow the instructions above to set the day, hour and minutes.
4. Once you have set the minutes and pressed the time button , the date and time are set and
the time is displayed.
5. If you want to change the date and time, press and hold the time button down for
approximately 3 seconds until the year number starts to flash. Now you can enter the new
values as described above.