BioSmart BIO-1400 OWA Owner's Manual - Unpacking Your New Biosmart
Page 9
©2014 BioSmart Technologies
Unpacking Your New BioSmart
®
Heater
1. INSPECT the package for any obvious damage.
2. UNPACK the heater: cut open taped box edges, fold back box flaps. Gently
turn entire box upside down; lift box from protective packaging.
3. REMOVE the protective packaging materials from the inside of the heater’s
heat exchanger, making sure that all combustible materials have been
removed from around the black ceramic heating elements.
4. INSPECT the unit to make sure that there are no cracks in the black ceramic
heating elements.
5. PROCEED with the “Mounting Guidelines” on page 10.
Heater Care & Storage
General Maintenance and Care
Routinely inspect the air registers on the unit to make sure that no dust has
accumulated. Vacuum as you would any conventional air duct.
It is suggested that an annual dusting of the ceramic plates be performed in order
to eliminate any residual accumulation of dust during the summer months. In
order to accomplish this, the front plastic panel must be removed by removing
the four screws and lifting up to release the panel from the top clip.
Heater Storage
When the heater is not being used for an extended period of time, observe the
following steps to preserve the life and performance of the unit:
• Unplug heater (Do not unplug heater while heater is running. Please see
Operating Instructions - Turning Power Off.) - This will also help you
conserve energy in your home or office.
• Gently wrap the power cord into the cord storage compartment. This
will help prevent undue wear and tear on the cord.
• Cover the heater to prevent dust from accumulating on or in heater.
• Store heater in a dry, low dust environment.