Biostar I865G-M7 User Manual - Table of Contents

Other manuals for I865G-M7: Engineering Validation Test Report
Manual is about: I865G-M7 compatibility test report

Summary of I865G-M7

  • Page 1

    I865g-m7 fcc information and copyright this equipment has been tested and found to comply with the limits of a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equ...

  • Page 2: Table of Contents

    Table of contents chapter 1: introduction ............................................................1 1.1 i865g-m7 features............................................................................1 a. Hardware.........................................................................................

  • Page 3: Chapter 1: Introduction

    I865g-m7 chapter 1: introduction 1.1 i865g-m7 f eatures a. Hardware cpu provides socket 775. Supports intel celeron d processor. Supports intel pentium 4 prescott processor. Supports hyper-threading technology. Front side bus at the following frequency ranges: - 533mt/s (133 mhz core clock) - 800mt/...

  • Page 4

    I865g-m7 environment control initiatives: ¾ h/w monitor, ¾ fan speed controller (optional), ¾ ite “smart guardian” function. Lan chip: rtl8100c supports 10/100mb/s auto-negotiation operation. Half/full duplex capability. Supports acpi, pci power management. Slot 3 x 32bits pci bus master slots. 1 x ...

  • Page 5

    I865g-m7 rear side connectors 4 usb 2.0 ports. 1 vga port. 1 serial port. 1 parallel port. 1 rj-45 lan jack. 1 ps/2 mouse & keyboard port. 1 vertical audio port including 1 line-in connector, 1 speaker out connector, and 1 mic in connector. Ps/2 keyboard ps/2 mouse lan line in/ surround line out mic...

  • Page 6

    I865g-m7 1.3 i865g-m7 l ayout jkbms1 jaudio1 jusblan1 jvga1 jcom1 par a llel por t c o m 1 vg a1 intel ich5 dd ra 1 dd ra 2 dd rb 1 dd rb 2 id e2 id e 1 fdd1 1 jcfan1 jatxpwr1 pci1 pci2 pci3 agp1 lan codec bios jatxpwr2 lga775 cpu1 intel 865g bat1 1 jusbv1 1 2 13 14 jaudio2 1 jspdif_out1 1 jusbv2 1 ...

  • Page 7

    I865g-m7 1.4 i865g-m7 c omponents intel ich5 lan codec bios lga775 cpu1 intel 865g bat1 super i/o a b c d e f g h i j k l m n o p q r s t u a. Jusbv2: power source header for jusblan1. L. Jpanel1: front panel facilities header. B. Jatxpwr2: atx power source header. M. Jci1: chassis open message head...

  • Page 8

    I865g-m7 chapter 2: hardware installation 2.1 c entral p rocessing u nit (cpu) special notice: remove pin cap before installation, and make good preservation for future use. When the cpu is removed, cover the pin cap on the empty socket to ensure pin legs won’t be damaged. Pin cap step 1: pull the l...

  • Page 9

    I865g-m7 step 2-2: step 3: hold the cpu down firmly, and then close the lever to complete the installation. Step 4: put the cpu fan on the cpu and buckle it. Connect the cpu fan power cable to the jcfan1. This completes the installation. 2.2 fan h eaders these fan headers support cooling-fans built ...

  • Page 10

    I865g-m7 2.3 m emory m odule i nstallation 1. Unlock a dimm slot by pressing the retaining clips outward. Align a dimm on the slot such that the notch on the dimm matches the break on the slot. 2. Insert the dimm vertically and firmly into the slot until the retaining chip snap back in place and the...

  • Page 11

    I865g-m7 2.4 c onnectors and s lots agp1: accelerated graphics port slot your monitor will attach directly to that video card. This motherboard supports video cards for pci slots, but it is also equipped with an accelerated graphics port (agp). An agp card will take advantage of agp technology for i...

  • Page 12

    I865g-m7 chapter 3: headers & jumpers setup 3.1 h ow to s etup j umpers the illustration shows how to set up jumpers. When the jumper cap is placed on pins, the jumper is “close”, if not, that means the jumper is “open”. Pin opened pin closed pin1-2 closed 3.2 d etail s ettings jusbv1/jusbv2/jusbv3_...

  • Page 13

    I865g-m7 jspdif_out1: digital audio-out connector this connector allows user to connect the pci bracket spdif output header. Pin assignment 1 +5v 2 spdif_out 1 jspdif_out1 3 ground jaudio1: front panel audio header this header allows user to connect the front audio out put cable with the pc front pa...

  • Page 14

    I865g-m7 jpanel1: front panel header this 24-pin connector includes power-on, reset, hdd led, power led, sleep button, speaker and irda connection. It allows user to connect the pc case’s front panel switch functions. 1 2 23 24 slp pwr_led on/off ir ir rst hled spk + + + - - jpanel1 pin assignment f...

  • Page 15

    I865g-m7 jatxpwr1/patxpwr2: power connectors jatxpwr1: this connector allows user to connect with 20-pin power connector on the atx power supply. Jatxpwr2: by connecting this connector, it will provide +12v to cpu power circuit. Pin assignment pin assignment 1 +3.3v 11 +3.3v 2 +3.3v 12 -12v 3 ground...

  • Page 16: Chapter 4: Useful Help

    I865g-m7 chapter 4: useful help 4.1 a ward bios b eep c ode beep sound meaning one long beep followed by two short beeps video card not found or video card memory bad high-low siren sound cpu overheated system will shut down automatically one short beep when system boot-up no error found during post...

  • Page 17

    I865g-m7 b. Cpu overheated if the system shutdown automatically after power on system for seconds, that means the cpu protection function has been activated. When the cpu is over heated, the motherboard will shutdown automatically to avoid a damage of the cpu, and the system may not power on again. ...

  • Page 18

    I865g-m7 4.3 t roubleshooting probable solution 1. No power to the system at all power light don’t illuminate, fan inside power supply does not turn on. 2. Indicator light on keyboard does not turn on. 1. Make sure power cable is securely plugged in. 2. Replace cable. 3. Contact technical support. S...

  • Page 19: Chapter 5:

    I865g-m7 chapter 5: warpspeeder™ 5.1 i ntroduction [warpspeeder™], a new powerful control utility, features three user-friendly functions including overclock manager, overvoltage manager, and hardware monitor. With the overclock manager, users can easily adjust the frequency they prefer or they can ...

  • Page 20

    I865g-m7 5.3 i nstallation 1. Execute the setup execution file, and then the following dialog will pop up. Please click “next” button and follow the default procedure to install. 2. When you see the following dialog in setup procedure, it means setup is completed. If the “launch the warpspeeder tray...

  • Page 21

    I865g-m7 5.4 [w arp s peeder ™] includes 1 tray icon and 5 panels 1. Tray icon: whenever the tray icon utility is launched, it will display a little tray icon on the right side of windows taskbar. This utility is responsible for conveniently invoking [warpspeeder™] utility. You can use the mouse by ...

  • Page 22

    I865g-m7 2. Main panel if you click the tray icon, [warpspeeder™] utility will be invoked. Please refer to the following figure; the utility’s first window you will see is main panel. Main panel contains features as follows: a. Display the cpu speed, cpu external clock, memory clock, agp clock, and ...

  • Page 23

    I865g-m7 3. Voltage panel click the voltage button in main panel, the button will be highlighted and the voltage panel will slide out to up as the following figure. In this panel, you can decide to increase cpu core voltage and memory voltage or not. The default setting is “no”. If you want to get t...

  • Page 24

    I865g-m7 4. Overclock panel click the overclock button in main panel, the button will be highlighted and the overclock panel will slide out to left as the following figure. Overclock panel contains the these features: a. “–3mhz button”, “-1mhz button”, “+1mhz button”, and “+3mhz button”: provide use...

  • Page 25

    I865g-m7 d. “auto-overclock button”: user can click this button and [warpspeeder™] will set the best and stable performance and frequency automatically. [warpspeeder™] utility will execute a series of testing until system fail. Then system will do fail-safe reboot by using watchdog function. After r...

  • Page 26

    I865g-m7 6. About panel click the “about” button in main panel, the button will be highlighted and the about panel will slide out to up as the following figure. In this panel, you can get model name and detail information in hints of all the chipset that are related to overclocking. You can also get...

  • Page 27

    I865g-m7 25 note: because the overclock, overvoltage, and hardware monitor features are controlled by several separate chipset, [warpspeeder™] divide these features to separate panels. If one chipset is not on board, the correlative button in main panel will be disabled, but will not interfere other...