BioTrack VT-NVR16 Quick Start Manual - page 6
Manual is about: ADR
of
9
Power ON
!
© Copyright 2015
VT-DVR
Quick Start Guide
5 |
P a g e
After connecting the camera and ADR as per the above connection diagram, please follow the below steps for power ON.
Note:
!
Make sure that the input voltage corresponds with the switch of the ADR power supply.
!
Power supply demands: 220V±10% /50Hz.
!
This%indicates%ADR%is%turned%
ON%
%
Plug the power
supply and turn
on the power
supply switch%
After%ADR%is%turned%ON,%you%will%
hear%a%beep!from%ADR.%This%
indicates%that%ADR%is%ready%for%
recording.
!