Bissell 1210 Series User Manual - Warning
Troubleshooting
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
problem
possible causes
Remedies
Reduced
spray oR
no spray
bladder may be empty.
Turn power switch off; refill bladder
with clean hot tap water and formula.
2-in-1 tank may not be seated
properly.
Turn power switch off; remove tank
and reseat tank.
Pump may have lost prime.
Turn power switch off; after 1 minute turn
on and depress spray release trigger.
The motor belt may be broken.
Follow belt replacement instructions
on page 12.
Dirtlifter
powerbrush
does not turn
The brush belt or motor belt is
off or broken.
Follow belt replacement instructions
on page 12.
cleaner
not picking
up solution
ReadyTools dial may be on the
wrong setting for the cleaning job.
set ReadyTools dial to either floor
cleaning or tools.
Poor tool position. (Hand held
attachments only).
Adjust angle; apply more downward
pressure.
Removable nozzle may not be
properly attached.
Make sure nozzle is on correctly by
slightly raising front of machine to line
up slots on the base of the machine
with the hooks on nozzle. Attach at
base first and then click nozzle into
place. Refer to image 5 on page 8.
2-in-1 tank lid is not properly installed. Re-install lid; refer to images on page 7.
2-in-1 tank is not properly seated.
2-in-1 tank must be firmly seated to
function; remove and reseat 2-in-1 tank.
2-in-1 tank has picked up
maximum dirty water.
empty 2-in-1 tank and refill, refer to
the Operation section.
The lint screen may be clogged.
Clean out lint screen. Refer to page 8.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a bissell product.
for any questions or concerns, bISSEll is happy to
be of service. contact us directly at 1-800-237-7691.
please do
not return
this product
to the store.
www.bissell.com
800.237.7691
13