1. DL manuals
  2. Bissell
  3. Vacuum Cleaner
  4. 18PO Series
  5. User Manual

Bissell 18PO Series User Manual

Manual is about: Bissell Vacuum Cleaner User Manual

Summary of 18PO Series

  • Page 1

    U s e r ’ s g u i d e 1 8 p 0 s e r i e s 4 3 z 3 s e r i e s 3 safety instructions product view assembly operation maintenance and care troubleshooting consumer services replacement parts 4 5-6 6-9 10-12 13 14 15 warranty 16 garage pro ™ v a c u u m ug110-4053_18p0_608.Indd 1 6/13/08 12:35:27 pm.

  • Page 2

    2 t hanks for buying a bissell vacuum 2 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 we’re glad you purchased a bissell garage pro™ vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your bissell garage pro™ va...

  • Page 3: Mportant Safety Instructions

    3 i mportant safety instructions when using an electrical appliance, basic precautions should be observed, including the following: read all instructions before using your garage pro vacuum. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and ...

  • Page 4: Roduct View

    4 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 wet/dry hose inlet blower hose outlet dirt tank face plate power switch power cord slots muffler dirt tank handles p roduct view ug110-4053_18p0_608.Indd 4 6/13/08 12:35:28 pm.

  • Page 5: Ssembly

    5 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 your unit will require no tools to put together. 1. Remove the dirt tank by pulling up on both handles to unlatch. Lift upper half of unit to remove. 2. Remove all accessories and parts stored in the bottom of the tank prior to use. 3. If the r...

  • Page 6: Ssembly

    Mounting & installation continued concrete wall (fasteners not included) you will need; (4) 3/8” x 2-1/4” concrete sleeve anchors. 1. Drill a 3/8” x 1-3/4” hole with a masonry drill bit. 2. Insert a bolt and anchor sleeve into the hole. 3. Align the bracket over the hole and mark remaining hole loca...

  • Page 7: Peration

    Wet or dry vacuuming mode 1. Attach hose to the wet/dry hose inlet opening (located on the front left side of the unit) by pushing fitted end of hose and turning clockwise until you feel it is secure. 2. Attach extension wand, if desired, to end of hose by pushing it firmly into the hose. 3. Attach ...

  • Page 8: Peration

    Thermal motor protection: an internal thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates, the main vacuum motor will stop operating. If this happens, proceed as follows. 1. Turn the vacuum off and unplug from electrical outlet. ...

  • Page 9: Peration

    Floor cleaning (2) extension wands use with desired attachment for a longer reach. Large area cleaning tool use on large surfaces for maximum pick up. Multi surface floor tool may be used on both carpet/rugs or hard floor surfaces. For use on carpets, make sure the tab is in the down position . This...

  • Page 10: Aintenance and Care

    10 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 m aintenance and care cleaning the dirt tank 1. Unplug the unit from electrical outlet. 2. Remove the dirt tank by pulling up on both handles to unlatch. 3. Ensure the dirt tank has been emptied. 4. The dirt tank may be washed in warm water. M...

  • Page 11: Aintenance and Care

    11 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 m aintenance and care cleaning the filters continued secondary filter 1. The secondary filter is located above the primary filter. 2. To remove the primary filter, see instructions on page 10. 3. To remove the secondary filter, pull filter dow...

  • Page 12: Aintenance and Care

    M aintenance and care 12 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 clearing clogs continued if the clog is contained near the bottom of the hose (close to where tools are attached), follow these steps: 1. Remove wand or tool. 2. Attach hose to the blower outlet and turn the power on. 3. ...

  • Page 13: Roubleshooting

    13 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 t roubleshooting vacuum cleaner won’t turn on possible causes remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker 3. Thermal protector activated 3. Allow c...

  • Page 14: Bissell Consumer Services

    14 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 for information about repairs or replacement parts, or questions about your warranty, call: bissell consumer services 1-800-237-7691 monday - friday 8 a.M. — 10 p.M. Et saturday 9 a.M. — 8 p.M. Et or write: bissell homecare, inc. Po box 3606 g...

  • Page 15

    16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 15 r eplacement parts - bissell garage pro™ vacuum you may purchase parts from your retailer, by calling bissell consumer services or by visiting our website. Below is a list of common replacement parts. While not all of these parts may have c...

  • Page 16

    16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 w arranty - bissell garage pro™ vacuum this warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instru...