U s e r ’ s g u i d e 3760/4220/6850/6860 series safety instructions 3 product diagram 4 assembly instructions 4-6 operation / special tools 6-9 maintenance 10-13 troubleshooting 14 warranty 16 replacement parts 15 consumer services 15 lift-off ® r e v o l u t i o n ™ ug603-5567_3760-6850_905.Indd 1...
2 thanks for buying a bissell lift-off ® revolution ™ we’re glad you purchased a bissell vacuum. Everything we know about floor care went into the design and construction of this powerful, high-tech home vacuuming system. Your bissell vacuum is well made, and we back it with a limited comprehensive ...
3 important safety instructions when using an electrical appliance, basic precautions should be observed, including the following: read all instructions before using your upright vacuum. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and befo...
4 caution: do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures. Power switch crevice tool handle quick release cord wrap handle release pedal powerfoot stretch hose power cord furniture protection guard height adjustment knob upper tank dirt conta...
How to use this guide this user’s guide has been designed to help you get the most satisfaction from your bissell vacuum. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this guide thoroughly before assembling ...
Snap the telescoping extension wand, crevice tool, and combination tool into storage clips as shown. On board turbobrush ® (select models only) the turbobrush bracket slides onto the hanger on the front of the handle. Attach the bracket by aligning the slots with the rectangular part on the hanger a...
The powerfoot on your vacuum can be adjusted to clean several floor surfaces. Note: for optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. Place handle in upright position. Turn height adjustment knob to desi...
Turbobrush ® (select models) : use rotating brush action for small areas such as stairs and upholstery. Note: press gently when using turbobrush to gain maximum cleaning. Too much pressure could cause the brush to stop rotating. Deluxe bare floor tool (select models): use for bare floors. Swivel hea...
9 select models only the shoulder strap may be used while cleaning with the detachable canister. To attach the shoulder strap, wrap the velcro ends attached to the bottom of the strap securely around the canister handle as shown. To obtain maximum strength, overlap the loose ends completely and pres...
Upper tank knob to maintain maximum cleaning performance, the following maintenance steps must be performed: empty the dirt container when the dirt reaches the “full” line on the front. Check the upper tank and pre-motor filters at least once a month and clean and replace as needed. Replace the hepa...
Unplug the cleaner from electrical outlet. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. If the filter becomes dirty, pull out the tray, lift out the filter and clean. This filter may be hand washed in cold water with ...
Place one end of the new drive belt over motor pulley and the other end over the brush in the space between the bristles. Pull the brush firmly to stretch the drive belt and place ends of brush down into slots on sides as shown. Turn brush several times by hand to center the drive belt. Reposition b...
Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs. Unplug cleaner from electrical outlet. Empty dirt container. Check upper tank for build up or clogs. Remove the upper tank a...
Vacuum cleaner won’t run possible causes remedies power cord not plugged in check electrical plug blown fuse/tripped breaker check/replace fuse or reset breaker thermal protector activated allow cleaner to cool for 30 minutes, see pg. 13 no power at rotating floor brush possible causes remedies cani...
15 replacement parts – bissell lift-off revolution series bissell consumer services 1 2 3 4 5 6 7 8 9 10 12 13 14 for information about repairs or replacement parts, or questions about your warranty, call: bissell consumer services 1-800-237-7691 monday - friday 8 a.M. — 10 p.M. Et saturday 9 a.M. —...
Warranty 16 this warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact bissell consumer services by e-mail, telephone, o...
