Bissell 8931 SERIES User Manual - Belt Maintenance
6
to clean filter:
1. Turn power OFF (O).
2. Remove the dirt container from the hand
vacuum, as directed in step 1 “emptying the
dirt cup” on page 6.
3. Remove filter and tap firmly against the
inside of a waste container, removing any
visible dirt.
4. Replace filter back into the dirt container
and attach dirt container to hand
vacuum until it snaps securely in place.
NOtE: After heavy usage, you may clean
the filter by washing it gently by hand in
warm water and mild dish detergent.
Rinse thoroughly and make certain it is
completely dry before replacing it.
d3 brush roll and brush roll
belt maintenance
The brush roll may accumulate debris such
as strings, hair and fibers. This type of debris
can wrap around the brush and diminish its
ability to clean effectively.
to remove brush roll for cleaning:
1. Turn power OFF (O). Remove foot
assembly from unit and turn over to
access the brush roll.
2. Remove three Phillips head screws to
remove the belt cover.
3. To remove brush roll, pull on the brush
near the belt side. Clean off hair or other
debris from brush roll.
4. Place cleaned brush roll back into foot
of unit by aligning the non-belt side so it’s
seated in the nozzle.
5. Pivot the brush roll so the belt end slides
into the slot in the nozzle.
6. Replace the belt cover and secure with
three screws. Attach foot assembly
on unit.
brush roll reset:
if larger debris becomes lodged in the foot
of the unit and the brush roll shuts off, turn
the unit off and remove the obstruction.
Wait approximately 15 seconds for the
motor to cool down before turning back
on. brush will function again after allowing
time to cool down.
brush roll belt replacement:
if the brush roll belt should break, visit
www.bissell.com to purchase replacement
belt number 2031608.
Replacement instructions:
1. Turn power OFF (O). Remove foot
assembly from unit and turn over to
access the brush roll belt.
2. Remove three Phillips head screws to
remove the belt cover.
3. locate broken belt.
4. Replace belt.
5. Place brush roll back into foot of unit.
6. Replace the belt cover and secure with
three screws.
7. Attach foot assembly on unit.
d4 disposal of batteries
if your lift-Off Floors & More is to be
disposed of, the batteries should be
removed and disposed of properly.
1. IMPORTANT: Unplug Charger.
2. Remove hand vac from unit and remove
dirt cup from handle.
3. Remove (5) Phillips head screws on the
handle and cover.
4. separate left and right cover.
5. Remove the entire battery assembly from
the cover.
6. Remove (3) Phillips head screws between
the motor and battery bracket.
7. Pull the motor, PCb, fuse, and inner wire
through the middle of the battery bracket,
separating the battery bracket and single
battery from the motor, PCb, and inner wire.
8. Cut wires from the PCb and fuse to the
battery bracket.
9. Keep battery packs together – DO NOT
separate individual batteries. For proper
battery disposal instructions, please contact
your local authorities for requirements and
regulations on safe disposal or recycling
facilities in your area.
10. Discard remainder of product
cAutION: disconnecting the battery
will destroy the appliance and invalidate
the warranty.
English
www.bissell.com