1. DL manuals
  2. Bissell
  3. Vacuum Cleaner
  4. 92L3P
  5. User Manual

Bissell 92L3P User Manual

Manual is about: Baglesss vacuum

Summary of 92L3P

  • Page 1

    U s e r ’ s g u i d e 9 2 l 3 s e r i e s 3 safety instructions product view assembly operations maintenance and care troubleshooting consumer services replacement parts 4 5-6 6-10 11-16 16-17 18 18 additional accessories warranty 19 20 powerclean ® b a g l e s s v a c u u m ug110-4054_92l3_608.Indd...

  • Page 2

    2 t hanks for buying a bissell vacuum 2 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 we’re glad you purchased a bissell vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your bissell vacuum is well made, and w...

  • Page 3: Mportant Safety Instructions

    3 i mportant safety instructions when using an electrical appliance, basic precautions should be observed, including the following: read all instructions before using your upright vacuum. Always connect to a polarized outlet (left slot is wider than right). Unplug from outlet when not in use and bef...

  • Page 4

    4 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 handle power switch easy empty ™ dirt container headlight height adjustment knob foot window washable pre-motor filter carry handle lock ‘n seal ® lever hepa media post motor filter wide cleaning foot upper tank inner cyclone power cord crevice...

  • Page 5: Caution:

    5 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 the only tool you’ll need to assemble your vacuum cleaner is a phillips screwdriver. Attach handle to vacuum 1. Locate the handle and cord wrap. Remove the screw packet taped to the handle. 2. Stand the vacuum upright and from the rear of the u...

  • Page 6: Notice:

    Attach vacuum hose and tools 1. Attach the twist ‘n snap™ hose by lining up the tabs on the base with the corresponding notches on the back of the vacuum as shown. 2. Turn the twist ‘n snap hose to the right to lock the hose into place. 3. Grasping the quick reach handle, slide the end of the hose w...

  • Page 7

    Handle positions press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions. 1. Upright – for storage and above floor cleaning with tools. 2. Normal cleaning – press handle release pedal once. Position used f...

  • Page 8

    Transporting cleaner 1. To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward. 2. The cleaner can also be moved by using the carry handle. Special on-board tools your vacuum is not only a powerful carpet and rug clea...

  • Page 9: Caution:

    Special on-board tools (continued) crevice tool: use in tight narrow spaces. Extension wand: use with desired attachment for a longer reach. Hose wand: use with desired attachment for a longer reach or for cleaning hard to reach places. Turbobrush: use rotating brush action for small flat areas such...

  • Page 10

    Power cord usage 1. To use your vacuum, remove the cord and plug it into an electrical outlet. For your convenience, there is a quick release cord wrap for easy cord removal. There is also a cord clip that is part of the upper cord wrap where you can attach the cord when vacuuming. 2. When you are f...

  • Page 11: Warning:

    To maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters frequently. Perform the following maintenance steps: 1. Empty the dirt container when the dirt reaches the “full” line on the container, ...

  • Page 12: Warning:

    1. Unplug the vacuum from electrical outlet. 2. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. If the filter becomes dirty, pull out the tray, lift out the foam filter pad and clean it. Note: the pre-motor filter may be...

  • Page 13

    13 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 m aintenance and care replace drive belt 1. Unplug the vacuum from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (steps 1-4 of check rotating floor brush and drive belt), grasp old drive belt and remove from motor...

  • Page 14

    14 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 m aintenance and care replacing lightbulb 1. Unplug the vacuum from electrical outlet. 2. Using a screwdriver, first remove 2 screws on either side of lens and pull out to remove the lens. 3. Remove the bulb from the socket by grasping the bul...

  • Page 15

    15 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 m aintenance and care clearing clogs low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs. 1. Unplug the vacuum from electrical outlet. 2. Empty dirt container...

  • Page 16: Warning:

    16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 t roubleshooting vacuum cleaner won’t run possible causes remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker warning: to reduce the risk of electric shock...

  • Page 17

    17 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 t roubleshooting vacuum cleaner won’t run (continued) possible causes remedies 3. Damaged power cord 3. Unplug, check for damage, replace as necessary vacuum cleaner and tools won’t pick up dirt possible causes remedies 1. Incorrect height adj...

  • Page 18

    16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 18 1 for information about repairs or replacement parts, or questions about your warranty, call: bissell consumer services 1-800-237-7691 monday - friday 8 a.M. — 10 p.M. Et saturday 9 a.M. — 8 p.M. Et or write: bissell homecare, inc. Po box 3...

  • Page 19

    16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 19 1 2 3 4 5 these items are available for purchase as accessories for your bissell powerclean: to purchase call 1-800-237-7691 or visit www.Bissell.Com. Item part no. Part name 1 203-1056 crevice tool 2 203-1059 dusting brush/upholstery tool ...

  • Page 20

    16 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 20 w w w . B i s s e l l . C o m 8 0 0 . 2 3 7 . 7 6 9 1 w arranty - bissell powerclean ® vacuum this warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instr...