Bissell 94Z2E User Manual

Manual is about: Multi Cyclonic vacuum 220-240V

Summary of 94Z2E

  • Page 1

    U s e r ’ s g u i d e 76x6/94z2 series 220-240v 3 safety instructions 4 product view 5-6 assembly 6-9 operations 10-15 maintenance and care 16-17 troubleshooting 18 consumer services 19 19 additional accessories replacement parts 20 warranty ™.

  • Page 2: Mark J. Bissell

    2 t hank you for buying a bissell multi cyclonic vacuum 2 w w w . B i s s e l l . C o m we’re glad you purchased a bissell vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. By purchasing this product you are helping bi...

  • Page 3: Mportant Safety Instructions

    3 w w w . B i s s e l l . C o m i mportant safety instructions when using an electrical appliance, basic precautions should be observed, including the following: read all instructions before using your canister vacuum. Warning: to reduce the risk of fire, electric shock, or injury: ■ use indoors onl...

  • Page 4: Caution:

    4 w w w . B i s s e l l . C o m caution: do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures. P roduct view power switch turbobrush ™ (turbobrush ™ pet on select models) handle release switch dirt container pre-motor filter headlight height adjust...

  • Page 5: Ow to Use This Guide

    5 w w w . B i s s e l l . C o m h ow to use this guide a ssembly warning: plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children. This user’s guide has been designed to help you get the utmost satisfaction from your bissell vacuum. You’ll find assembly and ...

  • Page 6: Power Switch/brush Switch

    16 w w w . B i s s e l l . C o m attach vacuum hose and tools continued 3. Snap the telescoping extension wand, crevice tool, and combination tool into storage clips as shown. 4. The turbobrush snaps on to the holder on the front of the handle. Place the turbobrush in the holder by hooking the botto...

  • Page 7: Power Height Adjustment

    7 w w w . B i s s e l l . C o m power height adjustment the powerfoot on your vacuum can be adjusted to clean several floor surfaces. Note: for optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting. 1. Place hand...

  • Page 8: Special Tools Continued

    Buckle special tools continued turbobrush ™ pet (on select models): use for removing dirt and pet hair from stairs, upholstery, area rugs, and other small areas. Pull towards you in a raking motion. Note: turbobrush pet is designed to remove pet hair from upholstered or carpeted surfaces. It should ...

  • Page 9: Power Cord Storage

    16 w w w . B i s s e l l . C o m cleaning with the detachable canister the detachable canister feature makes it possible to easily take the powerful cleaning action of your bissell lift-off multi cyclonic to stairways, auto interiors, and other hard-to-reach areas of your home. Before detaching the ...

  • Page 10: Empty Dirt Container

    To maintain maximum cleaning performance, the following maintenance steps must be performed: 1. Empty the dirt container when the dirt reaches the “full” line on the front. 2. Check the pre-motor filter at least once a month and clean and replace as needed. 3. Replace the hepa media post-motor filte...

  • Page 11: Aintenance and Care

    11 w w w . B i s s e l l . C o m m aintenance and care cleaning the secondary cyclone unplug the cleaner from electrical outlet. 1. The secondary cyclone can be reached by removing the dirt container, reaching underneath the upper tank and turning the rim of the frame to unlock. Pull straight down t...

  • Page 12: Aintenance and Care

    M aintenance and care check your vacuum cleaner’s rotating floor brush and drive belt regularly for debris, wear or damage. Debris can wrap around the brush and hamper its ability to effectively clean your carpet. 1. Unplug cleaner from electrical outlet. 2. Remove detachable canister from vacuum cl...

  • Page 13: Warning:

    Warning: to reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. M aintenance and care replace light bulb 1. Unplug cleaner from electrical outlet. 2. Remove detachable canister and recline handle...

  • Page 14: Aintenance and Care

    M aintenance and care cleaning clogs low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs. 1. Unplug cleaner from electrical outlet. 2. Empty dirt container. 3. Check upper tank ...

  • Page 15: Aintenance and Care

    M aintenance and care thermal protector an internal thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates, the main vacuum motor will stop operating. If this happens, proceed as follows: 1. Turn the cleaner off (o) and unplug from ...

  • Page 16: Warning:

    Warning: to reduce the risk of electric shock, turn power off and disconnect plug from electrical outlet before performing maintenance or troubleshooting. T roubleshooting vacuum cleaner won’t run possible causes remedies 1. Power cord not firmly plugged in 1. Check electrical plug 2. Thermal protec...

  • Page 17: Roubleshooting

    T roubleshooting visible dirt escaping from cleaner possible causes remedies 1. Dirt container full 1. Empty dirt container 2. Filter or secondary cyclone missing or installed incorrectly 2. Check secondary cyclone, pre-motor and post-motor filter for correct installation 3. Dirt container installed...

  • Page 18: Issell Consumer Service

    B issell consumer service 18 w w w . B i s s e l l . C o m if your bissell product should require service: in the uk, australia, new zealand, the middle east or africa, call bissell consumer services at the numbers below and we will give you the location of a bissell authorized service center in you...

  • Page 19: Item

    Item part no. Part name 1 3200 style 8 drive belt (2-pack) 2 203-1297 standard headlight bulb 3 203-2073 twist ‘n snap hose 4 203-2085 brush roll - grey (other colors also available) 5 3290 style 8 pre-motor filter 6 3091 style 8 hepa media post-motor filter 7 203-2445 secondary cyclone 8 203-2444 s...

  • Page 20: Arranty - Bissell Lif-Off

    20 w w w . B i s s e l l . C o m ©2009 bissell homecare, inc grand rapids, michigan all rights reserved. Printed in korea part number 110-4162 rev 9/09 visit our website at: www.Bissell.Com w arranty - bissell lif-off ™ multi cyclonic series for uk inquiries: monday - thursday 9 am — 5 pm friday 9 a...