Bissell CLEAN LONG 48K2 Series User Manual

Other manuals for CLEAN LONG 48K2 Series: User Manual
Manual is about: Bissell Vacuum Cleaner User Manual

Summary of CLEAN LONG 48K2 Series

  • Page 1

    U s e r ’ s g u i d e 4 8 k 2 s e r i e s 3 safety instructions product view assembly operations maintenance and care troubleshooting consumer services replacement parts 4 5 6-9 10-12 13 14 15 warranty 16 cleanalong ™ ug110-4075_48k2_1208.Indd 1 ug110-4075_48k2_1208.Indd 1 12/22/08 10:16:13 am 12/22...

  • Page 2

    2 t hanks for buying a bissell cleanalong canister vacuum 2 w w w . B i s s e l l . C o m we’re glad you purchased a bissell cleanalong canister vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your bissell canister v...

  • Page 3: Mportant Safety Instructions

    3 w w w . B i s s e l l . C o m i mportant safety instructions when using an electrical appliance, basic precautions should be observed, including the following: read all instructions before using your canister vacuum. Always connect to a polarized outlet (left slot is wider than right). Unplug from...

  • Page 4: Caution:

    4 w w w . B i s s e l l . C o m caution: do not plug in your vacuum until you are familiar with all instructions and operating procedures. Dusting brush bristle brush tool holder p roduct view flex hose telescoping extension wand handle variable suction power control brush roll on/off crevice tool u...

  • Page 5: Warning:

    5 w w w . B i s s e l l . C o m a ssembling your vacuum 1. Connect swivel hose by squeezing both locking buttons and inserting it into the suction opening on the canister. Once the swivel hose is inserted in the suction opening, release the locking buttons. 2. Plug the cord from the hose into the sl...

  • Page 6

    O perations 6 w w w . B i s s e l l . C o m special tools your bissell cleanalong is not only a powerful carpet and rug vacuum cleaner, it’s also a versatile bare floor vacuum cleaner and above floor vacuum cleaner when you select one of the special tools. Powerhead: the cleanalong comes with the po...

  • Page 7: Caution:

    O perations 7 w w w . B i s s e l l . C o m power cord the power cord is located at the rear of the vacuum. Gently pull out the power cord, watching for the yellow line. Stop pulling the power cord once the yellow line is visible. There is also a red line, which indicates the end of the usable cord....

  • Page 8

    8 w w w . B i s s e l l . C o m o perations variable height adjustments step on the brush height adjuster located on the right side of the motorized powerhead to adjust for flooring type (lowest setting (1)for non-carpet, indoor areas, highest setting (6) for plush pile carpet). Handle position pres...

  • Page 9: Warning:

    9 w w w . B i s s e l l . C o m o perations bag change indicator the bag change indicator is located between the power button and the automatic cord rewind button. If the bag change indicator turns orange while you are vacuuming, the dust bag needs to be replaced. The dust bag may appear to be full ...

  • Page 10: Notice:

    10 w w w . B i s s e l l . C o m cleaning the pre-motor filter the pre-motor filter protects the motor from dirt and dust particles. 1. Unplug the vacuum from electrical outlet. 2. Disconnect hose 3. Open the dust bag compartment by lifting up on the latch on the door at the front of the vacuum. Lif...

  • Page 11

    11 w w w . B i s s e l l . C o m m aintenance and care the post-motor hepa media filter assists in the filtration process to return clean air to the room. 1. Unplug the vacuum from electrical outlet. 2. Remove the filter door (located on the rear of the vacuum) by pulling up on the filter door latch...

  • Page 12

    12 w w w . B i s s e l l . C o m m aintenance and care cleaning the motorized powerhead the brush can usually be cleaned without removal from the vacuum. If there is an excessive amount of hair and debris, however, it is best to remove the brush. 1. Unplug the vacuum. 2. Lay the motorized powerhead ...

  • Page 13: Warning:

    13 w w w . B i s s e l l . C o m t roubleshooting vacuum cleaner won’t run possible causes remedies 1. Vacuum cleaner is not plugged in 1. Check electrical plug 2. Power button is not pressed down 2. Press power button down vacuum cleaner won’t pick up or low suction possible causes remedies 1. Tool...

  • Page 14

    14 w w w . B i s s e l l . C o m b issell consumer services for information about repairs or replacement parts, or questions about your warranty, call or write: bissell consumer services 1-800-237-7691 monday - friday 8 a.M. — 10 p.M. Et bissell homecare, inc. Saturday 9 a.M. — 8 p.M. Et po box 3606...

  • Page 15

    R eplacement parts - bissell cleanalong item part no. Part name 1 203-7270 dust bag (3pk) 2 203-7268 pre-motor filter 3 203-7269 post-motor hepa media filter 4 203-7309 barefloor tool 5 203-7310 floor brush 6 203-7315 hose grip with powercord 7 203-7314 extension wand with power cord 8 203-7273 upho...

  • Page 16

    16 w w w . B i s s e l l . C o m w arranty - bissell cleanalong canister vacuum ©2008 bissell homecare, inc grand rapids, michigan all rights reserved. Printed in china part number 110-4075 rev 12/08 visit our website at: www.Bissell.Com this warranty gives you specific legal rights, and you may als...