Bissell Vac & Steam 1132 Series User Manual - Removing All Mop Pads
Maintenance & Care
Removing All Mop Pads
1. Unplug hard floor cleaner from electrical outlet.
2. Step on foot release for mop pad tray and
lift unit off tray.
3. Carefully remove mop pad from the mop
pad tray using the Quick Release™ Tab. The
mop pad and tray may be hot.
4. Put the mop pad tray back down on the
floor and set the unit back on top. It will click
into place.
5. The Microban® Mop pad can be machine
washed in warm water. Use only liquid
detergents. Do not use fabric softeners
or bleach. For best results, air dry.
6. For STEAMBOOST disposable pad (select
units), throw away after use. Do not flush.
Empty Dirt Tank
The dirt tank needs to be emptied when the dirt
reaches the ‘Full’ line on the side of the tank.
1. Unplug hard floor cleaner from electrical outlet.
2. Remove the Easy Empty dirt tank from the
unit by moving the lock button on the front of
the unit to the left.
3. Hold the dirt tank over a garbage container.
Press the bottom lid release button on the back
of the dirt tank to empty dirt.
4. Mount the Easy Empty dirt tank back on the
vacuum base and push the lock button to the
right until it is centered on the front of the unit.
NOTE: The dirt tank may be washed in warm
water with a mild detergent. Make sure it is
completely dry before replacing.
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
www.BISSELL.com
9
2.
3.
CAUTION
Upright storage of the cleaner with a wet mop pad may
result in the formation of white marks on your floor. To
remove the white marks, clean area with vinegar.
2.