- DL manuals
- Bull
- Burner
- 96000
- Assembly & Operating Instructions
Bull 96000 Assembly & Operating Instructions
Summary of 96000
Page 1
Assembly & operating instructions model #96000 power burner, l.P. (propane) model #96001 power burner, n.G. (natural gas).
Page 2: Table Of Contents
Table of contents page # safety instructions……………………...…………………………………………………….………………………..………………………...2 the location for your power burner………………………………………………………….....……….…………………........2 checking for gas leaks………………………………………………………………………………………...…..……………………..2 natural gas safety…………………………………….……………………….…...
Page 3: Safety Instructions
Safety instructions this power burner must be installed in accordance with local codes or, if in an area without local codes, with the latest edition of the national fuel gas code ansi z223.1. In canada, installation must conform to the standard can/ cga 1-b149.1 and/or .2 (installation code for gas...
Page 4: Safety Instructions
Safety instructions (cont.) natural gas safety your natural gas power burner is designed to operate on natural gas only, at a pressure of 4” water column (w.C.) regulated at the natural gas regulator attached at the back of the power burner. Check with your gas utility for local gas pressure and wit...
Page 5: Safety Instructions
Safety instructions (cont.) propane gas safety your propane power burner is designed to operate on propane gas only, at a pressure regulated at 11” water column (w.C.) when equipped with the correct propane orifices and a propane regulator on the supply line regulated at the residential meter. Your ...
Page 6: Installation Instructions
Installation instructions yourpower burner comes to you fully assembled. We strongly recommend professional installation and hookup of the gas power burner. These instructions will provide you with the measurements necessary for you or your builder to construct a masonry structure to house your outd...
Page 7: Installation Instructions
Installation instructions (cont.) outdoor natural gas power burner installation specifications note: - when choosing a location for your power burner keep in mind that it should never be located under any overhead combustible construction. - the sides and back of the power burner should not be any c...
Page 8: Installation Instructions
Installation instructions (cont.) outdoor propane gas power burner installation specifications note: - when choosing a location for your power burner keep in mind that it should never be located under any overhead combustible construction. - the sides and back of the power burner should not be any c...
Page 9: Orifices
Inspecting i cleaning burner and gas orifices by following these cleaning procedures on a timely basis, your power burner will be kept clean and working properly with minimum effort. Caution – always turn off the gas supply prior to clearing your power burner. Burner cleaning 1. Remove burner from t...
Page 10: Orifices
Inspecting i cleaning burner and gas orifices (cont.) 4. Remove the burner by sliding it through the cutout in the insert assembly. Note: it’s easiest to remove the burner by rotating it 90° so that the burner tube faces the front. 5. Bend a stiff wire and run it through the burner tube several time...
Page 11: Orifices
Inspecting i cleaning burner and gas orifices (cont.) burner shutter clip inspection / adjustment the burner is set to a factory setting; however the air to fuel mixture may need to be adjusted to accommodate different gas pressures. In order to adjust the air to fuel mixture, loosen the screw and r...
Page 12: Orifices
Inspecting / cleaning burner and gas orifices (cont.) igniter / electrode check with all control knobs set to “off”, check each igniter individually for presence of spark at electrode. In turn, push each control knob in fully and turn slowly about a 1/4 turn to the left (counter-clockwise) until a c...
Page 13: Lighting Procedures
Lighting & operating instructions lighting procedures lighting burner(s): 1. Become familiar with the safety guidelines at the front of the manual. Do not smoke while lighting power burner or checking gas supply connections! 2. If yourpower burner fuel source is a lp gas cylinder, check to see that ...
Page 14: Cleaning & Maintenance
Cleaning & maintenance cleaning the grates after cooking, turn control knobs to “off” and let power burner cool before attempting to clean your grates. Before first use and periodically it is suggested that you wash the grates in a mild soap and warm water solution. You can use a washcloth or a vege...
Page 15: Troubleshooting
Troubleshooting if power burner fails to operate properly 1. Turn off gas at source, turn control knobs to “off”, and wait five minutes before trying again. 2. Check gas supply/connections. 3. Repeat lighting procedure. If power burner still fails to operate properly, turn “off” gas at source, turn ...
Page 16: Parts List
Parts list model #96000 power burner, l.P. (propane) model #96001 power burner, n.G. (natural gas) how to order replacement parts please refer to the parts list on this page. To make sure you obtain the correct replacement parts for your power burner, the following information is required to assure ...
Page 17: Exploded Illustration
Exploded illustration 16.
Page 18: Limited Warranty
Limited warranty bull outdoor products, inc. Warrants to the original purchaser at the original site of delivery with proof of purchase of each outdoor power burner that when subject to normal residential use, it is free from defects in workmanship and materials for the periods specified below. This...