Bull DPX/20 Installation And Configuration Manual - page 6
iv
FDDI Adapters – Installation and Configuration Guide
Electronic Emission Notices
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for Class B digital
devices, pursuant to Part 15 of the FCC Rules. Operation is subject to the following
conditions:
1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause
undesired operation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If interference problems do occur, please consult the system equipment owner’s manual for
suggestions. Some of these suggestions include relocation of the computer system away
from the television or radio or placing the computer AC power connection on a different
circuit or outlet.
Changes or modifications to this equipment not expressly approved by Bull could
result in non-FCC compliance, and void the user’s authority to operate this
equipment.
This product was tested and certified with a shielded cable/unshielded cable; depending on
the availability of the port, therefore, an appropriate cable is to be used.
Industry Canada Compliance Statement
This digital apparatus does not exceed the Class B limits for radio noise for digital apparatus
as set out in the interference–causing equipment standard entitled: “Digital Apparatus”,
ICES–003 of the Department of Communications.
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux
appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur :
“Appareils numériques”, NMB–003 édictée par le ministère des Communications.
BMPT Vfg 243/1991
Hiermit wird bescheingt, dass {die FDDI UDP Single und FDDI Fiber Single/Dual adapters}
in Übereinstimmung mit dem Bestimmung der BMPT-AmtsblVfg 243/1991 funk-entstört ist.
Der vorschriftsmässige Betrieb mancher Geräte (Z.B. Messender) kann allerdings gewissen
Einschrankungen unterliegen. Beachten Sie deshalb die Hinweise in der
Bedienungsanleitung.
Dem Zentralamt für Zulassungen in Fernmeldewesen wurde das Inverkehrbringen dieses
Gerätes angezeigt und die Berechtigung zur Überprüfung der Serie auf die Einhaltung der
Bestimmungen eingeraumt.