Bulldog Security 791P Operating Manual

Summary of 791P

  • Page 1

    This module is needed if you are installing a remote starter on any of the following vehicles: acura 3.2tl 98+, cl 97+, integra 00+, mdx 01+, nsx, rl 98+,rsx 01+, tl 98+, tsx 04+; buick century 97+, lesabre 90-96, 00+, park avenue 91+, regal 93-96, riviera 93-96, roadmaster 93-96, rendezvous 02+, sk...

  • Page 2

    791 universal bypass module the model 791 interface module is used when installing remote start products in any vehicle equipped with an anti-theft system including bmw, audi, volvo and mercedes. The ford pats, gms pk3, vats, passlock i, passlock ii or any other transponder systems. This model allow...

  • Page 3

    Passkey (vats) installation (gm only) this fuel system shutdown anti-theft system is based on a pellet (resistor) built into the steel shaft of the ignition key. When the key is inserted into the ignition switch, the vats (vehicle anti-theft system) computer reads the value of the resistor to make s...

  • Page 4

    4 9 passkey (vats) install ation (gm only. Cont.) stripe wire on the remote starter that ............ Is connected to the starter/crank wire on .....The ignition switch harness. 8. The purple and the green wires are not used and should be taped up. 9. Put the key in the ignition switch and start ..T...

  • Page 5

    8 5 passlock i installation (gm only) this fuel system shutdown anti-theft system is based on a resistor built into the ignition switch. The system is recognized by a security light on the dashboard cluster. 1. Locate the harness coming from the ignition switch inside, find the three small wires yel...

  • Page 6

    6 7 8. Attach the yellow with black stripe wire to the large yellow with black stripe wire on the remote starter that is connected to the starter/crank wire on the ignition switch harness. 9. Attach the white wire from the bypass module to the large white wire on the remote starter that is connected...