Bulldog Security Deluxe 62I Installation And Owner's Manual

Other manuals for Deluxe 62I: Installation And Owner's Manual
Manual is about: Deluxe Remote Starter with Alarm and keyless Entry

Summary of Deluxe 62I

  • Page 1

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc deluxe 62i deluxe remote starter with alarm and keyless entry i n s t a l l a t i o n a n d o w n e r ’ s g u i d e bulldog security www.Bulldogsecurity.Com 225 technology way • steubenville, oh 43952 800-878-8007.

  • Page 2

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc your warranty fcc/id j3s0045choo - this device complies with part 15 of fcc rules and regulations. Operation of this unit is subject to the following two conditions. (1) this device may not cause harmful interference. (2) this device must accep...

  • Page 3

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 3 system features ............................................................................ 3-5 system components.......................................................................... 5 technical assistance..................................

  • Page 4

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 4 system features 25 security system features starter immobilizer prevents the vehicle from being hotwired when the system is with relay armed. Remote car finder helps you locate your vehicle in a crowded parking lot. Remote valet remotely turn...

  • Page 5

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 5 system features 24 keyless entry features remote keyless entry* remotely locks and unlocks your power door locks with built-in relays onboard. Remote programmable a programmable feature that locks and unlocks the doors when the ignition contr...

  • Page 6

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 6 23 you have chosen one of the most advanced remote starter systems ever made. This system is a technological breakthrough utilizing the most advanced, state-of-the-art technology and components. It is computer controlled and manufactured in t...

  • Page 7

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 22 7 precautions this system is designed to be used with fuel-injected and diesel vehicles with automatic transmissions only. Safety first! Never remote start the vehicle if it is indoors or if the keys are in the ignition. Always be sure that ...

  • Page 8

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 21 8 mechanical neutral safety switch (rear wheel drive only) when installing a bulldog security remote starter on gm vehicles or dodge dakotas built prior to 1996, you must: use the diagram below to create a circuit that will prevent the remot...

  • Page 9

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 20 9 run the antenna 4-pin harness up the windshield pillar on the driver’s side and across the top of the windshield tucking the antenna harness inside the headliner, behind the rearview mirror. Note: before mounting the antenna to the windshi...

  • Page 10

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 19 10 9.Brown/black (-) diesel glow plug input 10. Not used installation diagram bulldog security m200 t ested t o comply with fcc standards 1-8 00-878-8007 www.Bulldog security.Com f c c 12v(+) 12v(+) yellow/ black white/ black 5-pin harness i...

  • Page 11

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 18 11 connecting the 18-pin harness 1. Brown (+) or (-) parking light output attach to the vehicles parking light wire. Note: adjust the switch for positive or negative output. 2. Orange (-) (opt. Part #773 req.) starter immobilizer output prov...

  • Page 12

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 17 12 6. Black/blue (-) hood switch input this feature will keep the engine from starting or shut off the engine when the hoop is opened. Locate a good chassis ground with one inch of clearance for adjustment. Do not install the hood switch in ...

  • Page 13

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 16 13 connecting the main power, ignition and accessory wires 1. Red (+) power input there are two large gauge red wires with 25 amp fuse holders that plug into the top of the control module. These two wires must attach to vehicles battery feed...

  • Page 14

    ©2003 jbs technologies, llc ©2003 jbs technologies, llc 15 14 testing doorlocks making main power, ignition and accessory connections to the ignition switch harness ignition switch harness in vehicle bulldog security m200 t ested t o comply with fcc standards 1- 800-878-8007 w ww .Bulldog security ....