1. DL manuals
  2. Bulldog Security
  3. Door
  4. KE100, KE150, 1702
  5. Installation Manual

Bulldog Security KE100, KE150, 1702 Installation Manual

Summary of KE100, KE150, 1702

  • Page 1

    System features ....................................... 1 system components ..................................... 1 technical assistance .................................. 1 before you begin ...................................... 1 precautions ......................................... 1-2 making wir...

  • Page 2

    System features four-button remote control remotely lock and unlock your car from a distance. Starter immobilizer you can’t steal what you can’t start. Most insurance companies offer a discount for this feature. (optional part #773 required on ke100 only.) trunk release remotely opens your trunk. (o...

  • Page 3

    Do not leave the interior or exterior lights on for an extended period of time as it may cause battery drain. Do not mount the control module until all connections have been made and tested. Using wire ties or double sided tape, mount the module under the dash. Making wiring connections 4. Insert th...

  • Page 4

    4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. 3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the left wire as shown. 2. Twist upper wires together, twist lower w...

  • Page 5

    Note: remove any paint below the spade connector. Factory bolt spade connector black ground wire starter immobilizer (-) (optional relay part #773 required for ke100 only) some vehicles have factory alarms. Fasd (-) (factory alarm shut down wire) (optional) the red with black stripe wire provides (-...

  • Page 6

    There are 3 basic system types: “type a” door lock test (most gms and most chryslers) probe both of your door lock wires going to the door lock switch these wires are usually located in the driver’s kick panel, attach one end of your test light to a good chassis ground. Using the vehicle’s door lock...

  • Page 7

    Note: you will need to cut factory wiring to make an end to end connection, see “making connections” on page 3. “type c” reverse polarity note: connect the purple with black stripe wire from the fuse to +12v constant power. Power door lock motor lock unlock red black blue/black unlock brown/black un...

  • Page 8

    Programming instructions to enter programming mode press button #4 for 10 seconds then release. You are now in programming mode. To exit programming mode press and release button #4 again. Programming 0.7 and 3.5 second door lock/unlock pulse time (this is used for european cars only) (used only wit...