1. DL manuals
  2. Bulldog Security
  3. Security System
  4. PRO_SERIES 6002
  5. Installation And Owner's Manual

Bulldog Security PRO_SERIES 6002 Installation And Owner's Manual

Summary of PRO_SERIES 6002

  • Page 1

    Contents installation guide • owner’s guide technical assistance all tech personnel are expertly qualified to answer any technical questions. Technicians are available monday through friday from 9:00 a.M. Until 8:00 p.M. And saturday 10:00 a.M. Until 4:00 p.M. Address 288 canton avenue • wintersvill...

  • Page 2

    System features 1 2 long range four-button remotes hand-held, easy to use and lets you operate the system from an extended distance. Keyless entry with onboard relays two onboard relays are provided to work any vehicle’s door locks without additional parts. This feature will remotely lock or unlock ...

  • Page 3

    System components technical assistance before you begin 2 precautions should you need help. First check our website at www.Bulldogsecurity.Com or call our toll-free tech support hotline monday through friday 9am-8pm and saturday 10am-4pm est at 800-878-8007. You must give the following information: ...

  • Page 4

    Making wiring connections 3 note: in most cases you should not cut your vehicle wire in two. 1. Strip back two inches of insulation on the wire from the remote starter. 2. Strip back one inch of insulation on the wire you need to connect to. 3. Separate the vehicle wire as shown. Make the separation...

  • Page 5

    4 caution: all wires must be wrapped with tape and wire tied. 4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. 3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the le...

  • Page 6

    5 4.Connect the siren's black wire to the third mounting screw, using the spade connector. Make sure this is a solid ground. 5.Connect the siren's red wire to the module's grey wire. Finding constant and ignition power your system requires 12 volts constant and ignition 12 volt that is only on when ...

  • Page 7

    6 installing the flashing led status indicator the led indicator installs inside your vehicle and should be installed as high as possible and be visible from all windows. Drill a 1/4" mounting hole in the dash panel or use the supplied mounting bracket. Connecting the led status indicator insert the...

  • Page 8

    7 optional connections testing: door locks there are three basic types: “type a” door lock test (most gms and some chryslers) probe both of your door lock wires going to the door lock switch usually located in the driver’s kick panel. Probe the lock and the unlock wires, the test probe will show a (...

  • Page 9

    8 wiring diagrams 8 7 6 5 4 3 2 1 16 15 14 13 12 11 9 blue : white : main connector how to use your remote transmitter arming press button #1 to arm the system. The siren will chirp 1 time, the lights will flash once, the power door locks will lock (if installed), and the led will flash slowly indic...

  • Page 10

    9 led status indicator the led (red light) provides valuable information about the system and is also a theft deterrent. Led status led display armed flashing slow disarmed off passive arming flashing fast (arming count down) valet constantly on violated zone triggered device # of flashes zone 2 on ...

  • Page 11

    10 lock/unlock with ignition on disarm the system and press and hold button #3 for (10) ten seconds or until the unit chirps once. Release button #3 then press and release button #2 within (2) two seconds. The unit will chirp once indicating that the unit is programmed to lock/unlock the doors with ...