1. DL manuals
  2. Bulldog Security
  3. Security System
  4. PRO-SERIES 5002
  5. Installation And Owner's Manual

Bulldog Security PRO-SERIES 5002 Installation And Owner's Manual

Summary of PRO-SERIES 5002

  • Page 1

    Contents installation guide • owner’s guide technical assistance all tech personnel are expertly qualified to answer any technical questions. Technicians are available monday through friday from 9:00 a.M. Until 8:00 p.M. And saturday 10:00 a.M. Until 4:00 p.M. Address 288 canton avenue • wintersvill...

  • Page 2

    System features 1 2 long range four-button remotes hand-held, easy to use and lets you operate the system from an extended distance. Keyless entry with onboard relays two onboard relays are provided to work any vehicle’s door locks without additional parts. This feature will remotely lock or unlock ...

  • Page 3

    System components technical assistance before you begin 2 precautions should you need help. First check our website at www.Bulldogsecurity.Com or call our toll-free tech support hotline monday through friday 9am-8pm and saturday 10am-4pm est at 800-878-8007. You must give the following information: ...

  • Page 4

    Making wiring connections 3 note: in most cases you should not cut your vehicle wire in two. 1. Strip back two inches of insulation on the wire from the remote starter. 2. Strip back one inch of insulation on the wire you need to connect to. 3. Separate the vehicle wire as shown. Make the separation...

  • Page 5

    4 4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connection. Secure with wire ties as shown. 3. Lay upper twisted pair of wires over right wire as shown. Bring lower twisted pair of wires up to meet the left wire as shown. 2. Twist upper wires together, twist lower...

  • Page 6

    5 connecting the starter immobilizer locate the cranking wire in the ignition switch harness. The cranking wire will show 12 volt only when the key is in the cranking position. Cut the wire in two. Try to crank the engine, it should not crank. 1.Connect the control module’s orange wire (-) output wh...

  • Page 7

    6 optional connections testing: door locks there are three basic types: “type a” door lock test (most gms and some chryslers) probe both of your door lock wires going to the door lock switch usually located in the driver’s kick panel. Probe the lock and the unlock wires, the test probe will show a (...

  • Page 8

    7 testing: door locks there are three basic types: “type a” door lock test (most gms and some chryslers) probe both of your door lock wires going to the door lock switch usually located in the driver’s kick panel. Probe the lock and the unlock wires, the test probe will show a (-) negative and the g...

  • Page 9

    8 how to use your remote transmitter arming press button #1 to arm the system. The siren will chirp 1 time, the lights will flash once, the power door locks will lock (if installed), and the led will flash slowly indicating the alarm is now armed. The engine starter is also disabled. Disarming press...

  • Page 10

    9 automatic passive arming to program automatic passive arming on, disarm the system, press and hold button #3 for 10 seconds, until the unit chirps once. Release button #3 then press and release button #3 again within (2) two seconds. The system will chirp once again to indicate that passive arming...

  • Page 11

    10 dual lock/unlock pulse off disarm the system, press and hold button #3 for 10 seconds or until the unit chirps once. Release button #3, press and release button #4 within (2) two seconds, the unit will chirp (4) four times. The unit is now programmed for dual lock/unlock pulse off. Setting shock ...