1. DL manuals
  2. Bulldog Security
  3. Car Alarm
  4. Pro-Series 7002
  5. Installation & Owners Manual

Bulldog Security Pro-Series 7002 Installation & Owners Manual

Manual is about: Bulldog Security Remote Car Finder OWNER'S GUIDE

Summary of Pro-Series 7002

  • Page 1

    Contents installation guide • owner’s guide technical assistance all tech personnel are expertly qualified to answer any technical questions. Technicians are available monday through friday from 9:00 a.M. Until 8:00 p.M. And saturday 10:00 a.M. Until 4:00 p.M. Address 288 canton avenue • wintersvill...

  • Page 2

    System features 1 2 long range four-button remotes hand-held, easy to use and lets you operate the system from an extended distance. Keyless entry with onboard relays two onboard relays are provided to work any vehicle’s door locks without additional parts. This feature will remotely lock or unlock ...

  • Page 3

    System components technical assistance before you begin 2 should you need help. First check our website at www.Bulldogsecurity.Com or call our toll-free tech support hotline monday through friday 9am-8pm and saturday 10am-4pm est at 800-878-8007. You must give the following information: •name •telep...

  • Page 4

    Making wiring connections 3 precautions note: in most cases you should not cut your vehicle wire in two. 1. Strip back two inches of insulation on the wire from the remote starter. 2. Strip back one inch of insulation on the wire you need to connect to. 3. Separate the vehicle wire as shown. Make th...

  • Page 5

    4 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie them together. Use this method for all connections. Caution: all wires must be wrapp...

  • Page 6

    5 locating & making connections mounting and connecting the siren select a location under the vehicle's hood for the siren. •the mounting location should be solid and have no moving parts nearby. •for the loudest sound, the siren should point down. •the siren should not point straight up as moisture...

  • Page 7

    6 4.Most vehicles use a (-) negative switch, but if your does not, you will need to test for a (+) positive door pin switch. 5.Connect your meter or test light's negative lead to a good solid chassis ground. Use the positive lead or other lead probe to the door pin switch wire. Then open the door. I...

  • Page 8

    7 optional connections light will glow bright on both the lock and the unlock wires. Press and hold the lock button on the switch and test the lock wire. The correct wire will test (+) positive and the red light will glow bright. Release the lock button and this wire should show a (-) negative and t...

  • Page 9

    Antenna placement 8 note: once you have made the connections for the 5-pin door lock harness, you will need to plug the door lock harness into the main module 5-pin plug on the front of the unit. “type b” (-) negative (5-pin harness) ground unlock lock green/black unlock green/white not used red/bla...

  • Page 10

    9 wiring diagrams figure 1 8 7 6 5 4 3 2 1 16 15 14 13 12 11 9 blue : white : main connector 1. Red (+) 12 volt constant 2. Black chassis ground 3. Grey (+) siren output 4. White/red button #3 / channel #3 (-) output: window rollup, etc. 200 ma max 5. White/yellow button #2 / channel #2 (-) output: ...

  • Page 11

    10 car finder while the system is armed, press and release button #3. The alarm will chirp 6 times and the parking lights will flash. This is used to locate your vehicle in a crowded parking lot. Optional accessories (trunk pop, etc., opt. Part #775 required) note: when the alarm is disarmed, press ...

  • Page 12

    Arming only, after the unit is disarmed it reverts back to high theft off. Shock sensitivity reduction to reduce the on-board shock sensitivity to 50% (for this arming only), press button #1 again within two seconds after arming. The system will chirp once (or flash the parking lights once if silent...