1. DL manuals
  2. Bulldog Security
  3. Remote Starter
  4. RS202
  5. Installation And Owner's Manual

Bulldog Security RS202 Installation And Owner's Manual

Other manuals for RS202: Owner's Manual

Summary of RS202

  • Page 1

    Contents remote starter • models rs202/rs202e installation guide • owner’s guide system features ......................................1 system components ....................................1 required tools .......................................1 technical assistance .................................

  • Page 2

    System features system components technical assistance should you need help. First check our website at www.Bulldogsecurity.Com/wires.Htm or call our toll-free tech support hotline monday through friday 9am-8pm and saturday 10am-4pm est at 800-878-8007. You must give the following information: •name...

  • Page 3

    2 before you begin making wiring connections 1. Strip back two inches of insulation on the wire from the keyless entry. 2. Strip back one inch of insulation on the wire you need to connect to. One inch of bare wire two inches of bare wire congratulations, you have purchased one of the most advanced ...

  • Page 4

    3 4. Insert the wire from the unit through the hole as shown. 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie them together. Use this ...

  • Page 5

    4 heater/blower motor wire(s) (+12v in run position only) most vehicles will have (1) blower wire; however some fords, newer gm vehicles and chrysler 94 and up will have (2) or more blower wires. To locate these wire(s) probe for wire(s) that only show +12v when the ignition switch is in the run pos...

  • Page 6

    5 brake input the brake wire is located on the switch near and above the brake pedal. The correct wire will show +12v only when the brake is pressed. Connect the blue with black stripe from the 18-pin harness to this wire. Parking lights (+12v only with parking lights on) turn the parking lights to ...

  • Page 7

    6 caution: before connecting the 18-pin harness to the module, double check all connections to be sure they are secure and properly wrapped with electrical tape. Mount the unit under the driver’s side dash. Make sure to properly place antenna. (see antenna placement page 15.) plug the 18-pin harness...

  • Page 8

    7 factory anti-theft systems for general motors cars only system 1: passkey i and ii system (1985 and up). This system has a resistor pill in the key. Measure resistance of the pill using a test meter. A bypass module is available, part #vats-wr module. System 2: passlock i and ii system (1995 and u...

  • Page 9

    Connecting “type b locks” • if your vehicle has a “type b” door locking system, connect the green with black stripe wire from the 18-pin harness to the door lock wire. Connect the brown with black stripe wire to the unlock wire. See diagram below. “type b” - negative type door locks used on most imp...

  • Page 10

    Auxiliary input if you wish to use this starter with an aftermarket alarm, connect the blue wire from the 18-pin harness to the second or third channel (-) output of your existing alarm. When the output is activated, a (-) signal will be supplied to the remote starter. Trunk release output (optional...

  • Page 11

    Cold start on and off (degree select) press and hold brake. Press and hold button #2 until the parking lights flash twice. Release. Press and hold button #2. Each parking light flash is a progression in degrees. Flash #1 is -40ºf, flash #2 is -30ºf, flash #3 is -20ºf, flash #4 is -10ºf, flash #5 is ...