1. DL manuals
  2. Bulldog Security
  3. Remote Starter
  4. RS302
  5. Installation And Owner's Manual

Bulldog Security RS302 Installation And Owner's Manual

Summary of RS302

  • Page 1

    Contents vehicle starter • model rs302 installation guide • owner’s guide system features ......................................1 system components ....................................1 required tools .......................................1 technical assistance .................................1 be...

  • Page 2

    System features system components technical assistance should you need help. First check our website at www.Bulldogsecurity.Com/wires.Htm or call our toll-free tech support hotline monday through friday 9am-8pm and saturday 10am-4pm est at 800-878-8007. You must give the following information: •name...

  • Page 3

    2 making wiring connections 4. Insert the wire from the unit through the hole as shown. 1. Strip back two inches of insulation on the wire from the keyless entry. 2. Strip back one inch of insulation on the wire you need to connect to. One inch of bare wire two inches of bare wire 3. Separate the ve...

  • Page 4

    3 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie them together. Use this method for all connections. Caution: all wires must be wrapp...

  • Page 5

    4 locating & making connections note: remove any paint below the spade connector. Factory bolt spade connector black ground wire please see the wiring chart on our website, www.Bulldogsecurity.Com. Constant power (+12v, key in any position including off) these wire(s) are in your vehicle’s main igni...

  • Page 6

    5 testing: door locks there are three basic types: “type a” door lock test (most gms and some chryslers) probe both of your door lock wires going to the door lock switch usually located in the driver’s kick panel. Attach the clip end of your test light to a good chassis ground. Using the vehicle’s d...

  • Page 7

    6 testing: door locks there are three basic types: “type a” door lock test (most gms and some chryslers) probe both of your door lock wires going to the door lock switch usually located in the driver’s kick panel. Attach the clip end of your test light to a good chassis ground. Using the vehicle’s d...

  • Page 8

    7 factory anti-theft systems for general motors cars only system 1: passkey i and ii system (1985 and up). This system has a resistor pill in the key. Measure resistance of the pill using a test meter. A bypass module is available, part #vats-wr module. System 2: passlock i and ii system (1995 and u...

  • Page 9

    Operating instructions if you are operating your rs302 from an existing alarm’s second channel output note: you may have to disarm your alarm before starting the car. 1. Before turning off the vehicle, always remember to set the heater or air conditioning for proper temperature desired. 2. To start ...