1. DL manuals
  2. Bulldog Security
  3. Remote Starter
  4. RS92
  5. Installation And Owner's Manual

Bulldog Security RS92 Installation And Owner's Manual

Summary of RS92

  • Page 1

    Contents remote starter models rs92 / rs92e installation guide • owner’s guide technical assistance all tech personnel are expertly qualified to answer any technical questions. Technicians are available monday through friday from 9:00 a.M. Until 8:00 p.M. And saturday 10:00 a.M. Until 4:00 p.M. Addr...

  • Page 2

    System features system components technical assistance should you need help. First check our website at www.Bulldogsecurity.Com/wires.Htm or call our toll-free tech support hotline monday through friday 9am-8pm and saturday 10am-4pm est at 800-878-8007. You must give the following information: •name...

  • Page 3

    Making wiring connections 1. Strip back two inches of insulation on the wire from the keyless entry. 2. Strip back one inch of insulation on the wire you need to connect to. One inch of bare wire two inches of bare wire 2 precautions this system is designed to be used with fuel-injected, automatic t...

  • Page 4

    4. Insert the wire from the unit through the hole as shown. 6. Use electrical tape to wrap. Be sure to cover the wire about two inches on either side of the connection. First pull the wire that you have just connected along side the wire you connected to, tape and wire tie them together. Use this me...

  • Page 5

    Accessory wire(s) that power the heater/blower motor (+12v in run or on positions) this wire is also in the main ignition switch harness usually located in the steering column. Make all connections as close to the ignition switch harness as possible. Most vehicles will have (1) accessory wire; howev...

  • Page 6

    5 note: remove any paint below the spade connector. Factory bolt spade connector black ground wire chassis ground locate an easy to get to bolt or screw located under the driver’s side of the dash and attach the black ground wire from the 11-pin harness securely as pictured. Brake input the brake wi...

  • Page 7

    6 mechanical neutral safety switch (rear wheel drive only) when installing a bulldog remote starter on gm vehicles or dodge dakotas built prior to 1996, you must: use the diagram below to create a circuit that will prevent the remote starter from starting the vehicle unless the key is removed from t...

  • Page 8

    7 for general motors cars only system 1: passkey i and ii system (1985 and up). This system has a resistor pill in the key. Measure resistance of the pill using a volt/ohm meter. A bypass module is available, part #vats-wr module. System 2: passlock i and ii system (1995 and up). Passlock does not h...

  • Page 9

    8 programming instructions entering programming mode make sure your vehicle is not running and the brake is pressed. The brake is to remain pressed as long as you want to remain in programming mode. Adding new transmitters press and hold the brake, then press and hold button #1 (start) on the workin...