User guide read before use! Do not use on high pressure laminate or solid wood www.Bullettools.Com • 208-772-0175 prt-ins-0220 revb.05.13 ©2013 bullet tools sst220 sst226 “make the cut!”.
2 1 read and understand this instruction manual before operating the ez shear ™ 2 if you are not thoroughly familiar with the operation of the ez shear ™ , obtain advice from a qualified instructor or call 800-406-8998 (intl.: 208-772-0175). 3 stay alert. Do not operate while under ...
3 sst220 set up sst226 set up you will need #2 & #3 phillips head screwdrivers and a 1/2” (13mm) socket or wrench. You will need #2 & #3 phillips head screwdrivers. Please review and verify parts included in box: please review and verify parts included in box: f. F. 6. 6. 8. 8. 1. 1. 1a. 1a. A. A. B...
4 4. To attach handle: for 220: insert item f screws and tighten with 1/2” wrench. For 226: insert item f screws through back stroke stop and tighten with item g hex wrench. Note: to ensure correct alignment, start each of the bolts by hand before using wrench. 3. Attach table a. Attach table to bas...
5 2 while gently pushing handle down, pull safety lock pin out, then lift handle. 1 3 5. Place the fence for 220: your ez shear is equipped with an aluminum fence which may be set to common roof pitches. (4/12, 6/12, 8/12, and 12/12) simply align with desired position and press pins into place. Note...
6 the 226 shear has two leverage modes mode 1: use the long-stroke cams (black lobes) only for lightweight products thicker than 1/2 inch. Mode 2: for all other recommended products, use the short-stroke cams (grey lobes). 1) remove any obstructions from under the blade. 2) push handle to the closed...
7 accessories all angle fence item #701af set any angle from 0 º to 90 º shear stand item #709 allows you to cut with the shear off the ground honing the blade maintenance push the handle down until blade is 1/4” (6mm) open. Lay the hone stone against the flat face of the blade (side toward the tab...
Www.Bullettools.Com • 1-208-772-0175 0 500 1000 1500 janka hardness scale note: due to extreme variations in wood density, your shear may or may not cut the products listed below recommended hardness cut limit on engineered wood flooring with the ez shear ™ 1250 recommended hardness cut limit on eng...
