BULLPRO BP600 User Manual - page 14
Turn on/Turn off
If the projector is a new one, please read the “projector install chapter,
place the projector and connect the cables,follow the below steps to turn
on/off
1.Put in two 7-size battery in
the remote control before using
2.Pull the power switch on
the backboard as the power light turn red
3.Press the power key on the remote or
panel ,the indicator light turn green
4.The lamp start working 2 seconds later, image projected on the screen
the machine is working smoothly
5.The new projector may have problems like image unclear or trapezoid distortion,
Please read “image adjustment” chapter
6.After the image is clear ,you may enjoy the program, in the meantime ,you can still
setup the system or adjust the parameters
1.Press the power button during using will lead the projector to standby mode
2.when the projector switch into standby mode ,the light will turn green
from red
Turn on
Turn off
P age
1 3
P a ge
1 2
Panel instruction
1
OK KEY
Confirm
AV/TV-KEY
Source key (VGA,HDMI,etc.)
2
3
Menu
open or close the Menu
5
D
irection key
Adjust with parameters, the same
function with the remote control
Indicator light
Red
: Standby mode
Green: Working mode
4
Power KEY
This button can lead the projector to
working/standby mode
6