Bully Dog Power Pup Installation Manual - Installation
INTRODUC
TION
PO
WER CHARTS
INST
ALL
ATION
RETURN T
O ST
OCK
TROUBLESHOOTING
/ F
AQ
UPD
ATE A
GENT
12
INSTALLATION
INsTallaTION INsTRUCTIONs
There are five stages to complete the installation of the Power Pup. All stages must be followed exactly for
proper installation to take place.
Stage 1: Pull fuses.
Pull all of the following fuses before installing. These fuses must be pulled so that communication between
the Power Pup and the vehicle ECM is not disrupted during a download.
• Aftermarket satellite tracking systems
• Fleet monitoring hardware
• Aftermarket gauges
• Automatic Transmission
After the download is successfully complete these fuses can be replaced.
Stage 2: Connect the Power Pup to the
Truck.
1. Locate the data port inside the ve-
hicle cab, usually located on the driver’s
side of the vehicle.
2. Remove the data port cover and
identify the number of pins on the data
port. The data port will either have six
or nine pins. This will determine which
plug you use during installation. Notice
that the data cord has both plug types at
the end.
3. Once you identify the correct plug
type for your vehicle application, con-
nect the cable to the top of the Power
Pup and then plug the data plug into
the vehicle data port.
Data Port
Data Cable
Important: Before installing pull all of the fuses mentioned below for the duration of the download.
After download is complete the mentioned fuses can be replaced.
Also make certain that the batteries have a full charge, and that there are no electronic devices run-
ning off of the batteries while the Power Pup is installing on the vehicle.
INST
ALL
ATION