Bultaco BRINCO R Quick Manual - page 9
WARNING
Enter the key provided by Bultaco to
unlock the battery safety lock.
Remove the battery retaining
screw.
Unplug the power cord from
the battery by hand turning the
connector housing a quarter turn
counterclockwise and pulling it
4.
3.
2.
1.
Hold the battery firmly, rotate it
slightly on its base to release the
anchoring with the chassis.
Once the battery is disconnected
from the lower support, raise the
battery to fully remove it. You can now
connect it to the charger.
Battery: Removal, charging and reassembling
To reassemble your battery, follow the steps described in
reverse order.
If you want to charge your battery without removing
it you must follow only step 1 and directly connect it to the
charger turning it counterclockwise.
The following charger indicators will inform you about
battery charge state:
Before removing the battery make sure your Brinco is
always disconnected. The battery may be damaged if
fully discharged.
While charging, place the battery horizontally in a safe
position and close to the socket.
When you plug the male connector to the battery, either the
moto-bike’s or the charger’s, be careful not to damage it.
The battery is
charging.
The battery is
fully charged.
Failure during
charging. Check
charger indications.
GET YOUR BRINCO READY