Bumble Bee 91959 Assembly And Operating Instructions Manual

Manual is about: ROTARY CULTIVATOR WITH 5.5 HP BRIGGS & STRATTON ENGINE

Summary of 91959

  • Page 1

    Rotary cultivator with 5.5 hp briggs & stratton ® engine model 91959 assembly and operating instructions 3491 mission oaks blvd., camarillo, ca 93011 visit our web site at: http://www.Harborfreight.Com to prevent serious injury, read and understand all warnings and instructions before use. Copyright...

  • Page 2

    Product specifications save this manual you will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front co...

  • Page 3

    3. Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. Protect others in the work area from debris such as chips and sparks. Provide barriers or shields as needed. Personal safety 1. Stay alert. Watch what you are doing, and use comm...

  • Page 4

    2. Do not use the power tool if the engine’s throttle control (71) does not turn it on or off. Any gasoline powered tool that cannot be controlled with the engine’s throttle control is dangerous and must be replaced. 3. Disconnect the engine spark plug wire from the spark plug before making any adju...

  • Page 5

    Sku 91959 for technical questions please call 1-800-444-3353 page 5 3. Always use recommended replacement parts. The recommended replace- ment parts are available from harbor freight tools. 4. Use safety equipment. Always wear ansi approved safety glasses under- neath a full face shield, a dust mask...

  • Page 6

    2. Keep the cultivator and surrounding area clean of flammable objects at all times. 3. When spills of fuel or oil occur, they must be cleaned up immediately. Dis- pose of fluids and cleaning materials as per any local, state, or federal codes and regulations. Store oil rags in a covered metal conta...

  • Page 7

    Properly and perform its intended function. Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any other condition that may affect proper operation. Any part that is damaged should be properly re- paired or replaced by a qualified technician. 3. Make sure to ...

  • Page 8

    Sku 91959 for technical questions please call 1-800-444-3353 page 8 california proposition 65 warnings 1. Warning! Operation of this cultivator and/or engine exhaust from this product contains chemicals known to the state of california to cause cancer, birth defects, or other reproductive harm. (cal...

  • Page 9

    Pre-start checks: 1. Important ! Prior to first using the cultivator, the engine must be filled with a high quality sae 10w-30 grade engine oil until the level of the oil is indicated as “full” on the oil dipstick. To do so, unscrew and remove the oil dipstick located on the engine crankcase. Fill t...

  • Page 10

    Sku 91959 for technical questions please call 1-800-444-3353 page 10 (to a maximum 11” deep). To do so, remove the two cotter pins (39). Remove the two pin shafts (38). Raise or lower the depth skid (57) to obtain the desired tilling depth. Then, replace the pin shafts and cotter pins. (see figure c...

  • Page 11

    Sku 91959 for technical questions please call 1-800-444-3353 page 11 to stop the cultivator: 1. Release your grip on the clutch handle (73), and allow it to return to its “neu- tral” position. (see figure d.) 2. Turn the throttle control (71) to its “stop” position. 3. Close the fuel valve on the en...

  • Page 12

    Sku 91959 for technical questions please call 1-800-444-3353 page 12 please read the following carefully the manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Nei- ther the manufacturer or distributor makes any representation or...

  • Page 13

    Parts list sku 91959 for technical questions please call 1-800-444-3353 page 13 note: some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Part # description qty. Part # description qty. 1 engine (5.5 hp) 1 38 pin shaft (0b8 x 40) 5...

  • Page 14

    Assembly diagram sku 91959 for technical questions please call 1-800-444-3353 page 14 38 39 27 26 16a1 16a2 no te : some par ts are listed and sho wn f or illustration purposes onl y , and are not a v ailab le idividuall y as replacement par ts..