Bumbleride Flyer Owner's Manual - page 7
www.bumbleride.com | 6
Remove the bumper bar and install the infant seat adapter bar. The back of the infant seat should rest along the
infant adapter bar [1]. Connect the safety belt strap to each plastic D-ring on either side of the seat harness.
Bring the belt over the infant seat. Buckle and tighten the strap [2].
WARNING: Some infant carriers will not be compatible with this stroller. To verify whether your infant carrier is
compatible with this stroller, please install the carrier without your child inside. Always ensure that the secondary
safety belt is securely fastened over the infant carrier before use.
Simply lift the footrest to adjust to a horizontal position [3]. To lower the footrest, simply pull on the corresponding
levers beneath the footrest simultaneously and lower to the desired position.
Insert buckles [A] and [B] into either side of the buckle housing [C] until they click into place securely.
Carefully adjust the harness straps to snugly fit your child by adjusting the sliders located on the shoulder straps,
waist straps and the central front strap. To open the harness, squeeze the buckle prongs and pull away from
the buckle housing [C].
WARNING: ALWAYS USE SAFETY HARNESS WHEN CHILD IS SEATED IN THE STROLLER.
A
B
C